From: "Ville Syrjälä" <ville.syrjala@linux.intel.com>
To: Rodrigo Vivi <rodrigo.vivi@gmail.com>
Cc: intel-gfx@lists.freedesktop.org
Subject: Re: [PATCH] drm/i915: Set primary plane enable at dpcntrl.
Date: Fri, 24 Jan 2014 16:58:05 +0200 [thread overview]
Message-ID: <20140124145805.GI9454@intel.com> (raw)
In-Reply-To: <1390504759-6078-1-git-send-email-rodrigo.vivi@gmail.com>
On Thu, Jan 23, 2014 at 05:19:19PM -0200, Rodrigo Vivi wrote:
> This patch allows system to safely recover after kms_psr_sink_crc check
> or any other similar case that might fail when PSR is enabled.
>
> Ville made and sent me this patch after noticing that primary plane enabled
> bit was set during test case and unset after failure. What was causing a hard
> and non-recoverable blank screen.
>
> After the failure when alternating from fbcon to x section it was possible to
> see and move mouse cursor, but nothing else. Everything else was fully black.
> A for dpms off/on also haleped to get screen back. But this patch seeting
> primary plane enabled bit propertly seemed more clean.
>
> v2: Fix identation issue.
>
> Cc: Ville Syrjälä <ville.syrjala@linux.intel.com>
> Signed-off-by: Rodrigo Vivi <rodrigo.vivi@gmail.com>
> ---
> drivers/gpu/drm/i915/intel_display.c | 11 +++++++++++
> 1 file changed, 11 insertions(+)
>
> diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
> index dde98020..ed5ffce 100644
> --- a/drivers/gpu/drm/i915/intel_display.c
> +++ b/drivers/gpu/drm/i915/intel_display.c
> @@ -2095,6 +2095,9 @@ static int i9xx_update_plane(struct drm_crtc *crtc, struct drm_framebuffer *fb,
> if (IS_G4X(dev))
> dspcntr |= DISPPLANE_TRICKLE_FEED_DISABLE;
>
> + if (intel_crtc->primary_enabled)
> + dspcntr |= DISPLAY_PLANE_ENABLE;
> +
> I915_WRITE(reg, dspcntr);
>
> linear_offset = y * fb->pitches[0] + x * (fb->bits_per_pixel / 8);
> @@ -2192,6 +2195,9 @@ static int ironlake_update_plane(struct drm_crtc *crtc,
> else
> dspcntr |= DISPPLANE_TRICKLE_FEED_DISABLE;
>
> + if (intel_crtc->primary_enabled)
> + dspcntr |= DISPLAY_PLANE_ENABLE;
> +
> I915_WRITE(reg, dspcntr);
>
> linear_offset = y * fb->pitches[0] + x * (fb->bits_per_pixel / 8);
> @@ -8586,6 +8592,11 @@ static int intel_gen7_queue_flip(struct drm_device *dev,
> intel_ring_emit(ring, i915_gem_obj_ggtt_offset(obj) + intel_crtc->dspaddr_offset);
> intel_ring_emit(ring, (MI_NOOP));
>
> + if (IS_VALLEYVIEW(dev) && intel_crtc->primary_enabled)
> + I915_WRITE(DSPCNTR(intel_crtc->plane),
> + I915_READ(DSPCNTR(intel_crtc->plane))
> + | DISPLAY_PLANE_ENABLE);
We should add some kind of big comment that this ugly hack is here for
PSR. I assume we're going to remove it eventually once someone figures
out why the port/pipe/PLL aren't shutting down during PSR. To wake the
hardware back from that state takes a lot more than just flipping a
plane enable bit.
> +
> intel_mark_page_flip_active(intel_crtc);
> __intel_ring_advance(ring);
> return 0;
> --
> 1.8.1.2
--
Ville Syrjälä
Intel OTC
next prev parent reply other threads:[~2014-01-24 14:58 UTC|newest]
Thread overview: 44+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-01-23 18:16 [PATCH 1/4] drm/i915: Set primary plane enable at dpcntrl Rodrigo Vivi
2014-01-23 18:16 ` [PATCH 2/4] drm/i915: move psr_setup_done to psr struct Rodrigo Vivi
2014-01-24 14:50 ` Ville Syrjälä
2014-01-24 16:02 ` Rodrigo Vivi
2014-01-23 18:16 ` [PATCH 3/4] drm/i915: Update PSR on resume Rodrigo Vivi
2014-02-05 19:04 ` [PATCH 1/2] " Rodrigo Vivi
2014-01-23 18:16 ` [PATCH 4/4] drm/i915: Add Baytrail PSR Support Rodrigo Vivi
2014-01-23 19:19 ` [PATCH] " Rodrigo Vivi
2014-01-24 14:53 ` Ville Syrjälä
2014-01-24 16:05 ` Rodrigo Vivi
2014-01-24 17:41 ` Ville Syrjälä
2014-01-28 19:47 ` [PATCH 4/4] " Rodrigo Vivi
2014-01-29 12:47 ` [PATCH] " Rodrigo Vivi
2014-01-29 13:12 ` Chris Wilson
2014-01-29 13:24 ` Rodrigo Vivi
2014-01-29 13:27 ` Chris Wilson
2014-01-29 13:54 ` Rodrigo Vivi
2014-01-29 14:02 ` Chris Wilson
2014-01-29 14:23 ` Rodrigo Vivi
2014-01-29 14:26 ` Chris Wilson
2014-01-29 19:20 ` Daniel Vetter
2014-01-29 14:55 ` Rodrigo Vivi
2014-01-29 19:21 ` Daniel Vetter
2014-02-01 11:34 ` Chris Wilson
2014-02-04 10:49 ` Daniel Vetter
2014-01-29 14:56 ` Ville Syrjälä
2014-01-29 15:47 ` Rodrigo Vivi
2014-01-29 16:38 ` Ville Syrjälä
2014-01-29 17:48 ` Rodrigo Vivi
2014-01-29 18:24 ` Ville Syrjälä
2014-01-29 15:50 ` Rodrigo Vivi
2014-01-30 13:02 ` Chris Wilson
2014-01-30 17:01 ` Rodrigo Vivi
2014-02-04 10:53 ` Daniel Vetter
2014-02-04 13:03 ` Rodrigo Vivi
2014-02-04 13:54 ` Daniel Vetter
2014-02-05 19:04 ` [PATCH 2/2] " Rodrigo Vivi
2014-02-07 17:24 ` Ville Syrjälä
2014-02-07 18:05 ` Rodrigo Vivi
2014-02-07 18:39 ` Ville Syrjälä
2014-02-12 16:29 ` [PATCH] " Daniel Vetter
2014-01-23 19:19 ` [PATCH] drm/i915: Set primary plane enable at dpcntrl Rodrigo Vivi
2014-01-24 14:58 ` Ville Syrjälä [this message]
2014-01-28 19:46 ` [PATCH 1/4] " Rodrigo Vivi
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20140124145805.GI9454@intel.com \
--to=ville.syrjala@linux.intel.com \
--cc=intel-gfx@lists.freedesktop.org \
--cc=rodrigo.vivi@gmail.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.