[U-Boot] POST in u-boot for P2020 process

[Wolfgang Denk <wd@denx.de>]

Dear Pradeep,

In message <1390803626357-172426.post@n7.nabble.com> you wrote:
> 
>           Thanks for replying, I have read the document, i have to enable
> the POST as well with the macro "CONFIG_POST" and "CONFIG_CMD_DIAG", but i
> am getting lot of compilation errors. Am i missing something while

It's difficult to tell when you do not mention what exactly you
selected / enabled, and when you do not tell us what these "lot of
compilation errors" are exactly (include a log?).

> configuring ??   And post.h is also getting generated, which describes the
> different types POST operation ( cache test, memory test... etc). All macros
> are there in post.h , is there anything which i need to include in
> configuration file ??

There are completely generic tests, there are SoC specific tests, and
there are board specific tests.  Depending on what you enabled, some
of these tests may ned to be implemented for your configuration.

Best regards,

Wolfgang Denk

-- 
DENX Software Engineering GmbH,     MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
HEALTH WARNING: Care Should Be Taken When Lifting This Product, Since
Its Mass, and Thus Its Weight, Is Dependent on Its Velocity  Relative
to the User.