[U-Boot] [PATCH v7 0/38] Switch over to real Kbuild

[Masahiro Yamada <yamada.m@jp.panasonic.com>]

Hello Gerhard.

> I really should have provided this earlier.  Wanted to run some
> more ARM tests, but haven't taken the time yet and did not want
> to further delay my "tested by" feedback.
> 
> Have run-tested v5 and v7 on PowerPC based hardware, and
> build-tested other iterations of the patch set.
> 
> Tested-by: Gerhard Sittig <gsi@denx.de>
>
> The test was done for MPC5121 on an ifm AC14xx board; the U-Boot
> binary works as expected, the fw_printenv(1) tool can be cross
> built as well as native, out-of-source builds work perfectly (and
> allow to identify where the source resides -- yay!).

Your close test is highly appreciated. Thanks!!
I will add your Tested-by creadit to 17/38, 21/38, 38/38
when I post v8.

I will also add your run-time test report to the cover letter of v8.

Run-time test report for another board:
I am testing with Xilinx Zynq ZC706 board.
("zynq_zc70x" entry in boards.cfg)
It is working as I expect and I also confirmed it can correctly boot
Linux Kernel.




Best Regards
Masahiro Yamada