Intel I350 mini-PCIe card (igb) on Mirabox (mvebu / Armada 370)

[jgunthorpe@obsidianresearch.com (Jason Gunthorpe)]

On Tue, Mar 25, 2014 at 10:03:29PM +0000, Neil Greatorex wrote:

> I then replaced it with mdelay(1000) out of interest, and it succeeded
> in detecting the card at boot. It then proceeded exactly as described
> by Willy in his later e-mail (it successfully registers an MSI-X
> interrupt for one port, and then proceeds to implode).

Seem to confirm not enough time after reset..

Try this (untested) debugging patch:

diff --git a/drivers/pci/host/pci-mvebu.c b/drivers/pci/host/pci-mvebu.c
index b8f2fc9..74e2e20 100644
--- a/drivers/pci/host/pci-mvebu.c
+++ b/drivers/pci/host/pci-mvebu.c
@@ -999,6 +999,34 @@ static int mvebu_pcie_probe(struct platform_device *pdev)
 
 		mvebu_pcie_set_local_dev_nr(port, 1);
 
+		/* Wait for the link to come up */
+		if (!mvebu_pcie_link_up(port)) {
+			unsigned int I;
+
+			dev_info(&pdev->dev, "Waiting for link up\n");
+			for (I = 0; I != 100; I++) {
+				udelay(100);
+				if (mvebu_pcie_link_up(port))
+					break;
+			}
+			dev_info(&pdev->dev, "Link is %u\n",
+				 mvebu_pcie_link_up(port));
+		}
+
+		/* Turn on CRS Software Visibility */
+		mvebu_writel(port, mvebu_readl(port, PCIE_CTRL_OFF) | BIT(31),
+			     PCIE_CTRL_OFF);
+
+		/* Read the vendor ID from the connected device */
+		mvebu_writel(port, PCIE_CONF_ADDR(1, 0, 0), PCIE_CONF_ADDR_OFF);
+		dev_info(&pdev->dev, "Vendor ID is %x\n",
+			 mvebu_readl(port, PCIE_CONF_DATA_OFF));
+		msleep(1000);
+		mvebu_writel(port, PCIE_CONF_ADDR(1, 0, 0), PCIE_CONF_ADDR_OFF);
+		dev_info(&pdev->dev, "Try 2: Vendor ID is %x\n",
+			 mvebu_readl(port, PCIE_CONF_DATA_OFF));
+
+
 		port->dn = child;
 		spin_lock_init(&port->conf_lock);
 		mvebu_sw_pci_bridge_init(port);

Also, are you using the "reset-gpios" DT property? If so, ensure the
delay is at least 100 ms.

There is still an oddball problem:

00:01.0 PCI bridge: Marvell Technology Group Ltd. Device 6710 (rev 01) (prog-if 00 [Normal decode])
	Bus: primary=00, secondary=01, subordinate=02, sec-latency=0

I think the subordinate bus should be 01 - not sure what is going on
there... Maybe related to the rescan problem..

Jason