Re: [PATCH 1/2] gpio: pl061: get gpio base from alias id

[Baruch Siach <baruch@tkos.co.il>]

Hi Haojian Zhuang,

On Tue, Apr 22, 2014 at 09:35:42AM +0800, Haojian Zhuang wrote:
> If gpio base number isn't specified, the gpio base will be find from
> the end of gpio number. In order to keep with schematics, use alias
> to get the ID of gpio chip.
> 
> Signed-off-by: Haojian Zhuang <haojian.zhuang@linaro.org>
> ---
>  .../devicetree/bindings/gpio/gpio-pl061.txt        | 31 ++++++++++++++++++++++

Binding documentation should be done in a separate patch.

>  drivers/gpio/gpio-pl061.c                          | 14 +++++++++-
>  2 files changed, 44 insertions(+), 1 deletion(-)
>  create mode 100644 Documentation/devicetree/bindings/gpio/gpio-pl061.txt
> 
> diff --git a/Documentation/devicetree/bindings/gpio/gpio-pl061.txt b/Documentation/devicetree/bindings/gpio/gpio-pl061.txt
> new file mode 100644
> index 0000000..164b5ba
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/gpio/gpio-pl061.txt
> @@ -0,0 +1,31 @@
> +PL061 GPIO controller bindings
> +
> +Required properties:
> +- compatible:
> +  - "arm,pl061", "arm,primecell".
> +- #gpio-cells : Should be two.
> +  - first cell is the gpio pin number
> +  - second cell is used to specify the gpio polarity:
> +      0 = active high
> +      1 = active low
> +- gpio-controller : Marks the device node as a GPIO controller.
> +- interrupt-controller : Marks the device node as an interrupt controller.
> +- #interrupt-cells : Should be two.
> +  - first cell is the hw irq number
> +  - second cell is used to specify the interrupt type:
> +      0 = default, unspecified type
> +      1 = rising edge triggered
> +      2 = falling edge triggered
> +      4 = high level triggered
> +      8 = low level triggered
> +
> +Example:
> +	gpio0: gpio@fc806000 {
> +		compatible = "arm,pl061", "arm,primecell";
> +		reg = <0xfc806000 0x1000>;
> +		interrupts = <0 64 0x4>;

The "interrupts" property should be mentioned above.

> +		gpio-controller;
> +		#gpio-cells = <2>;
> +		interrupt-controller;
> +		#interrupt-cells = <2>;
> +	};

baruch

-- 
     http://baruch.siach.name/blog/                  ~. .~   Tk Open Systems
=}------------------------------------------------ooO--U--Ooo------------{=
   - baruch@tkos.co.il - tel: +972.2.679.5364, http://www.tkos.co.il -