From: steve.capper@linaro.org (Steve Capper)
To: linux-arm-kernel@lists.infradead.org
Subject: [PATCH] arm64: mm: Create gigabyte kernel logical mappings where possible
Date: Thu, 1 May 2014 09:54:12 +0100 [thread overview]
Message-ID: <20140501085411.GA31607@linaro.org> (raw)
In-Reply-To: <4217068.6LErVYxoHJ@wuerfel>
On Wed, Apr 30, 2014 at 08:11:26PM +0200, Arnd Bergmann wrote:
> On Wednesday 30 April 2014 12:36:22 Steve Capper wrote:
> > We have the capability to map 1GB level 1 blocks when using a 4K
> > granule.
> >
> > This patch adjusts the create_mapping logic s.t. when mapping physical
> > memory on boot, we attempt to use a 1GB block if both the VA and PA
> > start and end are 1GB aligned. This both reduces the levels of lookup
> > required to resolve a kernel logical address, as well as reduces TLB
> > pressure on cores that support 1GB TLB entries.
> >
> > Signed-off-by: Steve Capper <steve.capper@linaro.org>
> > ---
> > Hello,
> > This patch has been tested on the FastModel for 4K and 64K pages.
> > Also, this has been tested with Jungseok's 4 level patch.
> >
> > I put in the explicit check for PAGE_SHIFT, as I am anticipating a
> > three level 64KB configuration at some point.
> >
> > With two level 64K, a PUD is equivalent to a PMD which is equivalent to
> > a PGD, and these are all level 2 descriptors.
> >
> > Under three level 64K, a PUD would be equivalent to a PGD which would
> > be a level 1 descriptor thus may not be a block.
> >
> > Comments/critique/testers welcome.
>
> It seems like a great idea. I have to admit that I don't understand
> the existing code, but what are the page sizes used here?
Actually, I think it was your idea ;-). I remember you talking about
increasing the mapping size when 4-level page tables were being
discussed. (I think I should have added a Reported-by, would be happy
to if you want?).
With a 64KB granule, we'll map 512MB blocks if possible, otherwise 64K.
And with a 4KB granule, the original code will map 2MB blocks if
possible, and 4KB otherwise.
The patch will make the 4KB granule case also map 1GB blocks if
possible.
>
> Does the code always use the largest possible page size, or does
> it just use either small pages or 1G pages?
The code will put down the largest mappings it can. As the physical
memory sizes/address are very likely to be aligned to whatever block
size we use; we are likely to achieve the maximum size for our
mappings.
>
> In combination with the contiguous page hint, we should be able
> to theoretically support 4KB/64KB/2M/32M/1G/16G TLBs in any
> combination for boot-time mappings on a 4K page size kernel,
> or 64KB/1M/512M/8G on a 64KB page size kernel.
>
A contiguous hint could be applied to these mappings. The logic would
be a bit more complicated though when we consider different granules.
For 4KB we chain together 16 entries, for 64KB we use 32. If/when we
adopt a 16KB granule, we use 32 entries for a level 2 lookup and
128 entries for a level 3 lookup...
The largest TLB entry sizes that I am aware of in play are the block
sizes (i.e. 2MB, 512MB, 1GB). So I don't think we'll get any benefit at
the moment for adding the contiguous logic.
Cheers,
--
Steve
> Arnd
next prev parent reply other threads:[~2014-05-01 8:54 UTC|newest]
Thread overview: 9+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-04-30 11:36 [PATCH] arm64: mm: Create gigabyte kernel logical mappings where possible Steve Capper
2014-04-30 18:11 ` Arnd Bergmann
2014-05-01 8:54 ` Steve Capper [this message]
2014-05-01 13:36 ` Arnd Bergmann
2014-05-01 16:20 ` Steve Capper
2014-05-02 1:03 ` Jungseok Lee
2014-05-02 9:11 ` Steve Capper
2014-05-02 8:51 ` Catalin Marinas
2014-05-02 9:21 ` Steve Capper
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20140501085411.GA31607@linaro.org \
--to=steve.capper@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.