From: Pablo Neira Ayuso <pablo@netfilter.org>
To: Florian Westphal <fw@strlen.de>
Cc: Eric Dumazet <eric.dumazet@gmail.com>,
netfilter-devel@vger.kernel.org, davem@davemloft.net,
netdev@vger.kernel.org
Subject: Re: [PATCH 32/34] netfilter: bridge: move br_netfilter out of the core
Date: Tue, 30 Sep 2014 10:56:22 +0200 [thread overview]
Message-ID: <20140930085622.GA3916@salvia> (raw)
In-Reply-To: <20140929231748.GA11709@breakpoint.cc>
On Tue, Sep 30, 2014 at 01:17:48AM +0200, Florian Westphal wrote:
> Eric Dumazet <eric.dumazet@gmail.com> wrote:
> > On Mon, 2014-09-29 at 14:39 +0200, Pablo Neira Ayuso wrote:
> > > Jesper reported that br_netfilter always registers the hooks since
> > > this is part of the bridge core. This harms performance for people that
> > > don't need this.
> > >
> > > This patch modularizes br_netfilter so it can be rmmod'ed, thus,
> > > the hooks can be unregistered. I think the bridge netfilter should have
> > > been a separated module since the beginning, Patrick agreed on that.
> > >
> > > Note that this is breaking compatibility for users that expect that
> > > bridge netfilter is going to be available after explicitly 'modprobe
> > > bridge' or via automatic load through brctl.
> > >
> > > However, the damage can be easily undone by modprobing br_netfilter.
> > > The bridge core also spots a message to provide a clue to people that
> > > didn't notice that this has been deprecated.
> > >
> > > On top of that, the plan is that nftables will not rely on this software
> > > layer, but integrate the connection tracking into the bridge layer to
> > > enable stateful filtering and NAT, which is was bridge netfilter users
> > > seem to require.
> > >
> > > This patch still keeps the fake_dst_ops in the bridge core, since this
> > > is required by when the bridge port is initialized. So we can safely
> > > modprobe/rmmod br_netfilter anytime.
> > >
> > > Signed-off-by: Pablo Neira Ayuso <pablo@netfilter.org>
> > > Acked-by: Florian Westphal <fw@strlen.de>
> > > ---
> >
> > Hmm... What am I missing here ?
> > # CONFIG_BRIDGE_NETFILTER is not set
>
> Nothing. Our fault. br_nf_core.o should not be built in this case.
>
> > $ make net/bridge/br_nf_core.o
> [..]
> > CC [M] net/bridge/br_nf_core.o
> > net/bridge/br_nf_core.c:77:1: error: expected identifier or ‘(’ before ‘{’ token
> > net/bridge/br_nf_core.c:88:12: error: redefinition of ‘br_nf_core_init’
>
> This patch seems to fix it for me. Pablo, can you double-check?
Thanks Florian, I'll pass this patch to David asap.
--
To unsubscribe from this list: send the line "unsubscribe netfilter-devel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
next prev parent reply other threads:[~2014-09-30 8:55 UTC|newest]
Thread overview: 47+ messages / expand[flat|nested] mbox.gz Atom feed top
2014-09-29 12:38 [PATCH 00/34] pull request: netfilter/ipvs updates for net-next Pablo Neira Ayuso
2014-09-29 12:38 ` [PATCH 01/34] netfilter: fix compilation of masquerading without IP_NF_TARGET_MASQUERADE Pablo Neira Ayuso
2014-09-29 12:38 ` [PATCH 02/34] netfilter: nf_tables: add NFTA_MASQ_UNSPEC to nft_masq_attributes Pablo Neira Ayuso
2014-09-29 12:38 ` [PATCH 03/34] netfilter: NFT_CHAIN_NAT_IPV* is independent of NFT_NAT Pablo Neira Ayuso
2014-09-29 12:38 ` [PATCH 04/34] netfilter: masquerading needs to be independent of x_tables in Kconfig Pablo Neira Ayuso
2014-09-29 12:38 ` [PATCH 05/34] netfilter: ipset: Fix static checker warning in ip_set_core.c Pablo Neira Ayuso
2014-09-29 12:38 ` [PATCH 06/34] netfilter: ipset: Add skbinfo extension kernel support in the ipset core Pablo Neira Ayuso
2014-09-29 12:38 ` [PATCH 07/34] netfilter: ipset: Add skbinfo extension kernel support for the bitmap set types Pablo Neira Ayuso
2014-09-29 12:38 ` [PATCH 08/34] netfilter: ipset: Add skbinfo extension kernel support for the hash " Pablo Neira Ayuso
2014-09-29 12:38 ` [PATCH 09/34] netfilter: ipset: Add skbinfo extension kernel support for the list set type Pablo Neira Ayuso
2014-09-29 12:38 ` [PATCH 10/34] netfilter: ipset: Add skbinfo extension support to SET target Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 11/34] netfilter: ipset: send nonzero skbinfo extensions only Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 12/34] netfilter: ipset: hash:mac type added to ipset Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 13/34] ipvs: Add simple weighted failover scheduler Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 14/34] ipvs: Add destination address family to netlink interface Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 15/34] ipvs: Supply destination addr family to ip_vs_{lookup_dest,find_dest} Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 16/34] ipvs: Pass destination address family to ip_vs_trash_get_dest Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 17/34] ipvs: Supply destination address family to ip_vs_conn_new Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 18/34] ipvs: prevent mixing heterogeneous pools and synchronization Pablo Neira Ayuso
2014-09-29 16:17 ` Sergei Shtylyov
2014-09-30 2:21 ` Simon Horman
2014-09-29 12:39 ` [PATCH 19/34] ipvs: Pull out crosses_local_route_boundary logic Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 20/34] ipvs: Pull out update_pmtu code Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 21/34] ipvs: Add generic ensure_mtu_is_adequate to handle mixed pools Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 22/34] ipvs: support ipv4 in ipv6 and ipv6 in ipv4 tunnel forwarding Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 23/34] ipvs: address family of LBLC entry depends on svc family Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 24/34] ipvs: address family of LBLCR " Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 25/34] ipvs: use correct address family in scheduler logs Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 26/34] ipvs: use the new dest addr family field Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 27/34] ipvs: Allow heterogeneous pools now that we support them Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 28/34] netfilter: nfnetlink: use original skbuff when committing/aborting Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 29/34] netfilter: nf_tables: export rule-set generation ID Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 30/34] net/netfilter/x_tables.c: use __seq_open_private() Pablo Neira Ayuso
2014-09-29 16:07 ` Sergei Shtylyov
2014-09-29 12:39 ` [PATCH 31/34] netfilter: bridge: nf_bridge_copy_header as static inline in header Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 32/34] netfilter: bridge: move br_netfilter out of the core Pablo Neira Ayuso
2014-09-29 22:04 ` Eric Dumazet
2014-09-29 23:17 ` Florian Westphal
2014-09-30 8:56 ` Pablo Neira Ayuso [this message]
2014-09-30 15:58 ` Stephen Hemminger
2014-10-01 10:33 ` Pablo Neira Ayuso
2014-09-29 12:39 ` [PATCH 33/34] netfilter: nf_tables: store and dump set policy Pablo Neira Ayuso
2014-09-29 16:14 ` Sergei Shtylyov
2014-10-01 13:47 ` Arturo Borrero Gonzalez
2014-09-29 12:39 ` [PATCH 34/34] netfilter: conntrack: disable generic tracking for known protocols Pablo Neira Ayuso
2014-09-29 18:54 ` [PATCH 00/34] pull request: netfilter/ipvs updates for net-next David Miller
2014-09-30 0:22 ` Simon Horman
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20140930085622.GA3916@salvia \
--to=pablo@netfilter.org \
--cc=davem@davemloft.net \
--cc=eric.dumazet@gmail.com \
--cc=fw@strlen.de \
--cc=netdev@vger.kernel.org \
--cc=netfilter-devel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.