[U-Boot] [PATCH] usb: musb-new: omap2430: Reset the MUSB controller early

[Marek Vasut <marex@denx.de>]

On Sunday, January 18, 2015 at 05:44:45 PM, Paul Kocialkowski wrote:
> When booting from USB peripheral boot, the bootrom will not properly deinit
> the MUSB controller, which doesn't clearly indicate an USB disconnection
> to the host and leaves U-Boot to deal with the state of the previous USB
> session.
> 
> On some host controller drivers (e.g. xhci_hcd), this ends up in a failure
> during set address, caused by the lack of proper disconnection
> notification.
> 
> Resetting the controller early in U-Boot notifies the host of the
> disconnection and doesn't hurt other use cases.
> 
> Signed-off-by: Paul Kocialkowski <contact@paulk.fr>
> ---
>  drivers/usb/musb-new/omap2430.c | 17 +++++++++++++++++
>  1 file changed, 17 insertions(+)
> 
> diff --git a/drivers/usb/musb-new/omap2430.c
> b/drivers/usb/musb-new/omap2430.c index 98f4830..6b256bb 100644
> --- a/drivers/usb/musb-new/omap2430.c
> +++ b/drivers/usb/musb-new/omap2430.c
> @@ -321,6 +321,7 @@ static int omap2430_musb_init(struct musb *musb)
>  {
>  	u32 l;
>  	int status = 0;
> +	int timeout = 10;
>  #ifndef __UBOOT__
>  	struct device *dev = musb->controller;
>  	struct omap2430_glue *glue = dev_get_drvdata(dev->parent);
> @@ -331,6 +332,22 @@ static int omap2430_musb_init(struct musb *musb)
>  		(struct omap_musb_board_data *)musb->controller;
>  #endif
> 
> +	/* Reset the controller */
> +	musb_writel(musb->mregs, OTG_SYSCONFIG, SOFTRST);
> +
> +	while (timeout--) {

Hi!

Just a minor nitpick, you might want to replace the timeout with get_timer(0) 
and friends, see for example drivers/spi/altera_spi.c:161 (the inner loop in 
spi_xfer() ).

+CC Hans, can you test on sunxi please ?

Thank you !

Best regards,
Marek Vasut