From: shawn.guo@linaro.org (Shawn Guo)
To: linux-arm-kernel@lists.infradead.org
Subject: [GIT PULL 2/3] ARM: imx: device tree changes for 3.20
Date: Fri, 23 Jan 2015 17:16:43 +0800 [thread overview]
Message-ID: <20150123091641.GC27337@dragon> (raw)
Hi Arnd, Olof,
Please note this change set depends on imx-soc-3.20, thanks.
Shawn
The following changes since commit c205389557aac828f8403db0368d1fc2ef859213:
ARM: imx: clk-vf610: Add clock for SNVS (2015-01-13 19:16:26 +0800)
are available in the git repository at:
git://git.kernel.org/pub/scm/linux/kernel/git/shawnguo/linux.git tags/imx-dt-3.20
for you to fetch changes up to 16baf8ddd84b36e6880092da777a67de362f8677:
ARM: dts: imx28-evk: remove duplicate property (2015-01-20 19:39:28 +0800)
----------------------------------------------------------------
The i.MX device tree update for 3.20:
- Update i.MX6 operating-points setting in device tree to match the
latest i.MX6 data sheet
- Add i.MX6SX sabreauto board support
- Add imx6dl-udoo board support based off imx6q-udoo
- Update sabrelite board to include I2C and HDMI support
- Update the VPU compatible strings to also use cnm,coda<model>
- Remove the ocram clock from the VPU node, as the clock is already
provided inside the ocram node
- Add system reset controller and syscon-reboot for VF610
- Update VF610 device tree to use zero based naming for GPIO nodes,
so that the number scheme matches hardware manual
- A number of random device additions like watchdog for VF610, sahara
for i.MX53, QSPI for imx6sx-sdb board, etc.
Note: the branch imx/soc was merged into imx/dt because the SNVS device
tree node needs to refer to the new clock ID added by the imx/soc patch.
----------------------------------------------------------------
Anson Huang (3):
ARM: dts: imx6q: update cpufreq volt/freq table
ARM: dts: imx6dl: correct cpufreq volt/freq table
ARM: dts: imx6sx: add i.mx6sx sabreauto board support
Anton Bondarenko (1):
ARM: dts: imx6q: enable dma for ecspi5
Eric Nelson (3):
ARM: dts: sabrelite: add i2c2
ARM: dts: sabrelite: add hdmi
ARM: dts: sabrelite: add i2c3
Fabio Estevam (3):
ARM: dts: imx: Update VPU compatible strings
ARM: dts: imx6qdl: Remove OCRAM clock from VPU node
ARM: dts: imx6sx-sdb: Add QSPI support
Gwenhael Goavec-Merou (1):
ARM: imx: apf51dev: add gpio-backlight support
Michael Heimpold (1):
ARM: dts: imx28-evk: remove duplicate property
Philippe Reynes (1):
apf27dev: add max5821 to the dts
Robert Nelson (1):
ARM: dts: imx6dl-udoo: Add board support based off imx6q-udoo
Sanchayan Maity (1):
ARM: dts: vfxxx: Add SNVS node
Shawn Guo (1):
Merge branch 'imx/soc' into imx/dt
Stefan Agner (4):
ARM: dts: vf610: enable watchdog for Cortex-A5 dt's
ARM: dts: vf-colibri: add CLKOUT pin to pinctrl of FEC1
ARM: dts: vf610: add system reset controller and syscon-reboot
ARM: vf610: use zero based naming for GPIO nodes
Steffen Trumtrar (1):
ARM: i.MX53: dts: add sahara module
arch/arm/boot/dts/Makefile | 2 +
arch/arm/boot/dts/imx27-apf27dev.dts | 21 +++++
arch/arm/boot/dts/imx27.dtsi | 2 +-
arch/arm/boot/dts/imx28-evk.dts | 1 -
arch/arm/boot/dts/imx51-apf51dev.dts | 14 +++
arch/arm/boot/dts/imx53.dtsi | 11 ++-
arch/arm/boot/dts/imx6dl-udoo.dts | 18 ++++
arch/arm/boot/dts/imx6dl.dtsi | 2 +-
arch/arm/boot/dts/imx6q-udoo.dts | 124 +------------------------
arch/arm/boot/dts/imx6q.dtsi | 4 +-
arch/arm/boot/dts/imx6qdl-sabrelite.dtsi | 33 +++++++
arch/arm/boot/dts/imx6qdl-udoo.dtsi | 134 +++++++++++++++++++++++++++
arch/arm/boot/dts/imx6qdl.dtsi | 5 +-
arch/arm/boot/dts/imx6sx-sabreauto.dts | 146 ++++++++++++++++++++++++++++++
arch/arm/boot/dts/imx6sx-sdb.dts | 39 ++++++++
arch/arm/boot/dts/vf-colibri-eval-v3.dtsi | 2 +-
arch/arm/boot/dts/vf-colibri.dtsi | 3 +-
arch/arm/boot/dts/vf500.dtsi | 23 ++++-
arch/arm/boot/dts/vf610-twr.dts | 2 +-
arch/arm/boot/dts/vfxxx.dtsi | 48 +++++++---
20 files changed, 484 insertions(+), 150 deletions(-)
create mode 100644 arch/arm/boot/dts/imx6dl-udoo.dts
create mode 100644 arch/arm/boot/dts/imx6qdl-udoo.dtsi
create mode 100644 arch/arm/boot/dts/imx6sx-sabreauto.dts
next reply other threads:[~2015-01-23 9:16 UTC|newest]
Thread overview: 2+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-01-23 9:16 Shawn Guo [this message]
2015-01-23 22:46 ` [GIT PULL 2/3] ARM: imx: device tree changes for 3.20 Olof Johansson
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20150123091641.GC27337@dragon \
--to=shawn.guo@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.