From: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
To: linux-kernel@vger.kernel.org
Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>,
stable@vger.kernel.org, Songjun Wu <songjun.wu@atmel.com>,
Bo Shen <voice.shen@atmel.com>, Mark Brown <broonie@kernel.org>
Subject: [PATCH 3.18 31/39] ASoC: atmel_ssc_dai: fix start event for I2S mode
Date: Mon, 9 Feb 2015 16:34:14 +0800 [thread overview]
Message-ID: <20150209083330.247937583@linuxfoundation.org> (raw)
In-Reply-To: <20150209083328.753647350@linuxfoundation.org>
3.18-stable review patch. If anyone has any objections, please let me know.
------------------
From: Bo Shen <voice.shen@atmel.com>
commit a43bd7e125143b875caae6d4f9938855b440faaf upstream.
According to the I2S specification information as following:
- WS = 0, channel 1 (left)
- WS = 1, channel 2 (right)
So, the start event should be TF/RF falling edge.
Reported-by: Songjun Wu <songjun.wu@atmel.com>
Signed-off-by: Bo Shen <voice.shen@atmel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
sound/soc/atmel/atmel_ssc_dai.c | 18 ++++--------------
1 file changed, 4 insertions(+), 14 deletions(-)
--- a/sound/soc/atmel/atmel_ssc_dai.c
+++ b/sound/soc/atmel/atmel_ssc_dai.c
@@ -345,7 +345,6 @@ static int atmel_ssc_hw_params(struct sn
struct atmel_pcm_dma_params *dma_params;
int dir, channels, bits;
u32 tfmr, rfmr, tcmr, rcmr;
- int start_event;
int ret;
int fslen, fslen_ext;
@@ -454,19 +453,10 @@ static int atmel_ssc_hw_params(struct sn
* The SSC transmit clock is obtained from the BCLK signal on
* on the TK line, and the SSC receive clock is
* generated from the transmit clock.
- *
- * For single channel data, one sample is transferred
- * on the falling edge of the LRC clock.
- * For two channel data, one sample is
- * transferred on both edges of the LRC clock.
*/
- start_event = ((channels == 1)
- ? SSC_START_FALLING_RF
- : SSC_START_EDGE_RF);
-
rcmr = SSC_BF(RCMR_PERIOD, 0)
| SSC_BF(RCMR_STTDLY, START_DELAY)
- | SSC_BF(RCMR_START, start_event)
+ | SSC_BF(RCMR_START, SSC_START_FALLING_RF)
| SSC_BF(RCMR_CKI, SSC_CKI_RISING)
| SSC_BF(RCMR_CKO, SSC_CKO_NONE)
| SSC_BF(RCMR_CKS, ssc->clk_from_rk_pin ?
@@ -475,14 +465,14 @@ static int atmel_ssc_hw_params(struct sn
rfmr = SSC_BF(RFMR_FSEDGE, SSC_FSEDGE_POSITIVE)
| SSC_BF(RFMR_FSOS, SSC_FSOS_NONE)
| SSC_BF(RFMR_FSLEN, 0)
- | SSC_BF(RFMR_DATNB, 0)
+ | SSC_BF(RFMR_DATNB, (channels - 1))
| SSC_BIT(RFMR_MSBF)
| SSC_BF(RFMR_LOOP, 0)
| SSC_BF(RFMR_DATLEN, (bits - 1));
tcmr = SSC_BF(TCMR_PERIOD, 0)
| SSC_BF(TCMR_STTDLY, START_DELAY)
- | SSC_BF(TCMR_START, start_event)
+ | SSC_BF(TCMR_START, SSC_START_FALLING_RF)
| SSC_BF(TCMR_CKI, SSC_CKI_FALLING)
| SSC_BF(TCMR_CKO, SSC_CKO_NONE)
| SSC_BF(TCMR_CKS, ssc->clk_from_rk_pin ?
@@ -492,7 +482,7 @@ static int atmel_ssc_hw_params(struct sn
| SSC_BF(TFMR_FSDEN, 0)
| SSC_BF(TFMR_FSOS, SSC_FSOS_NONE)
| SSC_BF(TFMR_FSLEN, 0)
- | SSC_BF(TFMR_DATNB, 0)
+ | SSC_BF(TFMR_DATNB, (channels - 1))
| SSC_BIT(TFMR_MSBF)
| SSC_BF(TFMR_DATDEF, 0)
| SSC_BF(TFMR_DATLEN, (bits - 1));
next prev parent reply other threads:[~2015-02-09 8:37 UTC|newest]
Thread overview: 43+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-02-09 8:33 [PATCH 3.18 00/39] 3.18.7-stable review Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 01/39] gpio: sysfs: fix memory leak in gpiod_export_link Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 02/39] gpio: sysfs: fix memory leak in gpiod_sysfs_set_active_low Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 03/39] gpio: mcp23s08: handle default gpio base Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 04/39] PCI: designware: Reject MSI-X IRQs Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 05/39] PCI: Add NEC variants to Stratus ftServer PCIe DMI check Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 06/39] PCI: Handle read-only BARs on AMD CS553x devices Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 07/39] spi: spi-fsl-dspi: Remove usage of devm_kzalloc Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 08/39] spi: imx: use pio mode for i.mx6dl Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 09/39] sd: Fix max transfer length for 4k disks Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 10/39] MIPS: Fix C0_Pagegrain[IEC] support Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 11/39] MIPS: IRQ: Fix disable_irq on CPU IRQs Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 12/39] MIPS: OCTEON: fix kernel crash when offlining a CPU Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 13/39] MIPS: Fix kernel lockup or crash after CPU offline/online Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 14/39] MIPS: mipsregs.h: Add write_32bit_cp1_register() Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 15/39] MIPS: traps: Fix inline asm ctc1 missing .set hardfloat Greg Kroah-Hartman
2015-02-09 8:33 ` [PATCH 3.18 16/39] ARM: 8299/1: mm: ensure local active ASID is marked as allocated on rollover Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 17/39] Complete oplock break jobs before closing file handle Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 18/39] md/raid5: fix another livelock caused by non-aligned writes Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 19/39] mm: pagewalk: call pte_hole() for VM_PFNMAP during walk_page_range Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 20/39] lib/checksum.c: fix carry in csum_tcpudp_nofold Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 21/39] memcg, shmem: fix shmem migration to use lrucare Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 22/39] nilfs2: fix deadlock of segment constructor over I_SYNC flag Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 23/39] drm/radeon: dont init gpuvm if accel is disabled (v3) Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 27/39] drm/radeon: properly set vm fragment size for TN/RL Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 29/39] arm64: Fix up /proc/cpuinfo Greg Kroah-Hartman
2015-02-09 8:34 ` Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 30/39] lib/checksum.c: fix build for generic csum_tcpudp_nofold Greg Kroah-Hartman
2015-02-09 8:34 ` Greg Kroah-Hartman [this message]
2015-02-09 8:34 ` [PATCH 3.18 32/39] ASoC: sgtl5000: add delay before first I2C access Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 33/39] ALSA: ak411x: Fix stall in work callback Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 34/39] ARM: dts: Fix I2S1, I2S2 compatible for exynos4 SoCs Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 35/39] x86, microcode: Return error from driver init code when loader is disabled Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 36/39] smpboot: Add missing get_online_cpus() in smpboot_register_percpu_thread() Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 37/39] hrtimer: Fix incorrect tai offset calculation for non high-res timer systems Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 38/39] tracing: Add condition check to RCU lockdep checks Greg Kroah-Hartman
2015-02-09 8:34 ` [PATCH 3.18 39/39] x86/tlb/trace: Do not trace on CPU that is offline Greg Kroah-Hartman
2015-02-09 16:40 ` [PATCH 3.18 00/39] 3.18.7-stable review Guenter Roeck
2015-02-09 18:27 ` Shuah Khan
2015-02-09 21:37 ` Greg Kroah-Hartman
2015-02-09 22:03 ` Guenter Roeck
2015-02-09 22:24 ` Winkler, Tomas
2015-02-09 23:19 ` Shuah Khan
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20150209083330.247937583@linuxfoundation.org \
--to=gregkh@linuxfoundation.org \
--cc=broonie@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=songjun.wu@atmel.com \
--cc=stable@vger.kernel.org \
--cc=voice.shen@atmel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.