From: Jesper Dangaard Brouer <brouer@redhat.com>
To: Alexander Duyck <alexander.duyck@gmail.com>
Cc: netdev@vger.kernel.org, Eric Dumazet <eric.dumazet@gmail.com>,
Alexei Starovoitov <ast@plumgrid.com>,
brouer@redhat.com
Subject: Re: [PATCH 2/2] pktgen: introduce xmit_mode 'rx_inject'
Date: Wed, 6 May 2015 10:44:42 +0200 [thread overview]
Message-ID: <20150506104442.009312cf@redhat.com> (raw)
In-Reply-To: <5549A772.9060009@gmail.com>
On Tue, 05 May 2015 22:32:34 -0700
Alexander Duyck <alexander.duyck@gmail.com> wrote:
> On 05/05/2015 01:30 PM, Jesper Dangaard Brouer wrote:
>
> <snip>
>
> > diff --git a/net/core/pktgen.c b/net/core/pktgen.c
> > index 43bb215..85195b2 100644
> > --- a/net/core/pktgen.c
> > +++ b/net/core/pktgen.c
> > @@ -210,6 +210,10 @@
>
> <snip>
>
> > @@ -3320,6 +3358,7 @@ static void pktgen_xmit(struct pktgen_dev *pkt_dev)
> > unsigned int burst = ACCESS_ONCE(pkt_dev->burst);
> > struct net_device *odev = pkt_dev->odev;
> > struct netdev_queue *txq;
> > + struct sk_buff *skb;
> > int ret;
> >
> > /* If device is offline, then don't send */
> > @@ -3352,11 +3391,45 @@ static void pktgen_xmit(struct pktgen_dev *pkt_dev)
> > pkt_dev->last_pkt_size = pkt_dev->skb->len;
> > pkt_dev->allocated_skbs++;
> > pkt_dev->clone_count = 0; /* reset counter */
> > + if (pkt_dev->xmit_mode == M_RX_INJECT)
> > + pkt_dev->skb->protocol = eth_type_trans(pkt_dev->skb,
> > + pkt_dev->skb->dev);
> > }
> >
>
> I was just wondering. Since M_RX_INJECT is not compatible with
> clone_skb couldn't the lines added above be moved down into the block
> below so that you could avoid the additional conditional jump?
Sure, that is possible. I'll let Alexei answer, as it is his code.
(And repost if he also thinks so...)
> > if (pkt_dev->delay && pkt_dev->last_ok)
> > spin(pkt_dev, pkt_dev->next_tx);
> >
> > + if (pkt_dev->xmit_mode == M_RX_INJECT) {
> > + skb = pkt_dev->skb;
> > + atomic_add(burst, &skb->users);
> > + local_bh_disable();
> > + do {
> > + ret = netif_receive_skb(skb);
> > + if (ret == NET_RX_DROP)
> > + pkt_dev->errors++;
> > + pkt_dev->sofar++;
> > + pkt_dev->seq_num++;
> > + if (atomic_read(&skb->users) != burst) {
> > + /* skb was queued by rps/rfs or taps,
> > + * so cannot reuse this skb
> > + */
> > + atomic_sub(burst - 1, &skb->users);
> > + /* get out of the loop and wait
> > + * until skb is consumed
> > + */
> > + pkt_dev->last_ok = 1;
> > + break;
> > + }
> > + /* skb was 'freed' by stack, so clean few
> > + * bits and reuse it
> > + */
> > +#ifdef CONFIG_NET_CLS_ACT
> > + skb->tc_verd = 0; /* reset reclass/redir ttl */
> > +#endif
> > + } while (--burst > 0);
> > + goto out; /* Skips xmit_mode M_TX */
> > + }
> > +
> > txq = skb_get_tx_queue(odev, pkt_dev->skb);
> >
> > local_bh_disable();
> > @@ -3404,6 +3477,7 @@ xmit_more:
> > unlock:
> > HARD_TX_UNLOCK(odev, txq);
> >
> > +out:
> > local_bh_enable();
> >
> > /* If pkt_dev->count is zero, then run forever */
> >
> > --
> > To unsubscribe from this list: send the line "unsubscribe netdev" in
> > the body of a message to majordomo@vger.kernel.org
> > More majordomo info at http://vger.kernel.org/majordomo-info.html
> >
>
--
Best regards,
Jesper Dangaard Brouer
MSc.CS, Sr. Network Kernel Developer at Red Hat
Author of http://www.iptv-analyzer.org
LinkedIn: http://www.linkedin.com/in/brouer
next prev parent reply other threads:[~2015-05-06 8:44 UTC|newest]
Thread overview: 38+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-05-01 5:12 [PATCH v3 net-next] pktgen: introduce 'rx' mode Alexei Starovoitov
2015-05-01 16:54 ` Eric Dumazet
2015-05-02 8:46 ` Jesper Dangaard Brouer
2015-05-02 9:44 ` Daniel Borkmann
2015-05-02 9:54 ` Jesper Dangaard Brouer
2015-05-02 10:30 ` Daniel Borkmann
2015-05-02 16:01 ` Alexei Starovoitov
2015-05-02 16:46 ` Jesper Dangaard Brouer
2015-05-02 17:07 ` Alexei Starovoitov
2015-05-05 18:15 ` Jesper Dangaard Brouer
2015-05-05 18:30 ` Alexei Starovoitov
2015-05-05 20:29 ` [PATCH 0/2] pktgen changes Jesper Dangaard Brouer
2015-05-05 20:29 ` [PATCH 1/2] pktgen: adjust flag NO_TIMESTAMP to be more pktgen compliant Jesper Dangaard Brouer
2015-05-05 20:30 ` [PATCH 2/2] pktgen: introduce xmit_mode 'rx_inject' Jesper Dangaard Brouer
2015-05-06 4:33 ` Alexei Starovoitov
2015-05-06 5:24 ` Jesper Dangaard Brouer
2015-05-06 10:17 ` Daniel Borkmann
2015-05-06 11:22 ` Jesper Dangaard Brouer
2015-05-06 5:32 ` Alexander Duyck
2015-05-06 8:44 ` Jesper Dangaard Brouer [this message]
2015-05-06 14:35 ` Alexei Starovoitov
2015-05-07 14:34 ` [PATCH v5 0/2] pktgen changes Jesper Dangaard Brouer
2015-05-07 14:34 ` [PATCH v5 1/2] pktgen: adjust flag NO_TIMESTAMP to be more pktgen compliant Jesper Dangaard Brouer
2015-05-07 14:35 ` [PATCH v5 2/2] pktgen: introduce xmit_mode '<start_xmit|netif_receive>' Jesper Dangaard Brouer
2015-05-07 16:28 ` Alexei Starovoitov
2015-05-07 17:11 ` Daniel Borkmann
2015-05-07 17:16 ` Alexei Starovoitov
2015-05-07 17:20 ` Daniel Borkmann
2015-05-08 13:40 ` Multiqueue pktgen (was: [PATCH v5 2/2] pktgen: introduce xmit_mode '<start_xmit|netif_receive>') Jesper Dangaard Brouer
2015-05-08 15:39 ` [PATCH v5 2/2] pktgen: introduce xmit_mode '<start_xmit|netif_receive>' Jesper Dangaard Brouer
2015-05-08 15:49 ` Multiqueue pktgen and ingress path (Was: [PATCH v5 2/2] pktgen: introduce xmit_mode '<start_xmit|netif_receive>') Jesper Dangaard Brouer
2015-05-08 15:56 ` Eric Dumazet
2015-05-08 16:53 ` Alexander Duyck
2015-05-08 17:00 ` Alexei Starovoitov
2015-05-08 18:21 ` Alexander Duyck
2015-05-08 15:57 ` [PATCH v5 2/2] pktgen: introduce xmit_mode '<start_xmit|netif_receive>' Eric Dumazet
2015-05-08 16:50 ` Alexei Starovoitov
2015-05-10 2:26 ` [PATCH v5 0/2] pktgen changes David Miller
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20150506104442.009312cf@redhat.com \
--to=brouer@redhat.com \
--cc=alexander.duyck@gmail.com \
--cc=ast@plumgrid.com \
--cc=eric.dumazet@gmail.com \
--cc=netdev@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.