Re: RPi model B - bluetooth-next kernel, shutdown always reboots the RPi

[Alexander Aring <alex.aring@gmail.com>]

On Fri, Jun 05, 2015 at 11:05:41AM +0200, Guido Günther wrote:
> On Thu, Jun 04, 2015 at 11:33:16AM +0200, Christoffer Holmstedt wrote:
> > On Thu, Jun 04, 2015 at 09:41:26AM +0200, Alexander Aring wrote:
> > > On Thu, Jun 04, 2015 at 08:34:16AM +0200, Christoffer Holmstedt wrote:
> > > > I know some of you are using the RPi as well so I start by asking here, perhaps
> > > > linux-rpi-kernel list is the next step. When I run "shutdown -h 0" the RPi
> > > 
> > > Maybe try "halt"? "halt" should shutdown your RPi, means unmounting
> > > filesystems etc. and stops there (without rebooting) Then it should be
> > > safe to pull the plug.
> > > 
> > > To poweroff the RPi, the RPi can't do that, it only can reboot itself
> > > which is solved by some watchdog timeout, I suppose. Maybe there exists
> > > self-builded solutions somewhere on RPi sites to shutdown the RPi
> > > somehow (means poweroff).
> > > 
> > > - Alex
> > 
> > "shutdown -h 0", halt, poweroff all end up with the same result. Rebooting
> > U-Boot and eventually starting Raspbian.
> > 
> > Yea, I probably have to look deeper into some RPi sources and find out how it
> > works in the 3.18.y series.
> 
> This might not help much but I'm seeing the same behaviour here but did
> not get around to look into this.
> Cheers,

I am using barebox [0] as bootloader and not seeing this issue. When I
type "halt" several messages are shown and ends with:

[  127.095945] reboot: System halted

no reboot.

- Alex

[0] http://barebox.org/