Re: [PATCH 4/5] staging: wilc1000: use pr_* instead of printk

[Dan Carpenter <dan.carpenter@oracle.com>]

On Mon, Aug 17, 2015 at 01:59:44PM -0400, Raphaël Beamonte wrote:
> 2015-08-17 13:47 GMT-04:00 Dan Carpenter <dan.carpenter@oracle.com>:
> >> -                             printk("[Sendconfigpkt]Get Timed out\n");
> >> +                             pr_debug("[Sendconfigpkt]Get Timed out\n");
> >
> >
> > Possibly pr_err()?
> 
> Yep. My mistake. I'll do the same for Set Timed Out also!
> 
> >> -                     printk("DBG [%s: %d]", __func__, __LINE__);     \
> >> -                     printk(__VA_ARGS__);                            \
> >> +                     pr_debug("DBG [%s: %d]", __func__, __LINE__);   \
> >> +                     pr_debug(__VA_ARGS__);                          \
> >
> > This is a behavior change, I think.  pr_debug() needs to be turned on?
> 
> Yes... I didn't pay attention to that! pr_debug needs -DDEBUG in the makefile.
> Should I use pr_info here? Or just acknowledge the behavior change for
> the moment,
> as the next aim is probably, as you said, to remove all the local
> debug code? (it is
> actually part of the TODO of this driver... So I could just work on that next.)

I would probably just do the rest and leave this part as-is since you're
planning to redo it all anyway.  I guess just do stuff which is obvious
and hopefully more and more stuff will become obvious as you go along.
This is a lazy answer but I don't want to think about this driver very
hard...  :P

Also always try to order your patches from least controversial to most
controversial.  It makes it easier to redo things or sometimes Greg
applies the first part of a patch series.

regards,
dan carpenter