Re: [PATCH] [PATCH v5] mtd:spi-nor: Add Altera Quad SPI Driver

[Marek Vasut <marex@denx.de>]

On Thursday, August 20, 2015 at 11:18:14 AM, Viet Nga Dao wrote:

Hi,

[...]

> >> That is why we decided to upstream the
> >> driver. If the hardware fix, there might not need to have any changes
> >> in driver to support or if yes, it will be just minor.
> > 
> > If the hardware can do proper READID opcode, this entire nonsense table
> > will go away and a proper integration into the SPI NOR framework will
> > take place.
> > 
> > You might consider submitting this driver for staging, but I definitely
> > am not a big fan of that.
> 
> You might misunderstand the hardware problem i mention here. This soft
> IP controller is able to provide the ID for our Altera EPCS/EPCQ flash
> chips, which are non JEDEC chips. As from EPCQ device data sheet
> (https://www.altera.com/content/dam/altera-www/global/en_US/pdfs/literature
> /hb/cfg/cfg_cf52012.pdf), the device ID is 8 bit data.

So what exactly is the output of READID instruction followed by 6 Byte read
on an EPCQ chip?

> The remaining
> problem here is that this controller is able to support Micron chips but
> it currently has
> limitation in providing only 8 bit ID, which is not full JEDEC ID for
> Micron chips.

OK

> Hence, we are asking hardware engineer to find out the
> solution so that the driver does not need to do any dirty hacking. And
> so, this table should still be here even hardware fix will take place
> or not.

[...]

Best regards,
Marek Vasut