Re: [PATCH/RFC v6 05/36] leds: Improve setting brightness in a non sleeping way

[Andrew Lunn <andrew@lunn.ch>]

> This work queue from led-class.c is used for setting brightness, when
> blink timer is on. Blinking is the functionality from the LED core,
> so the work queue should also belong to the core. It should be moved
> there along with led_timer_function, for consistency reasons. In view
> of the above, using it for setting brightness by blocking drivers
> would be correct from the architectural point of view.

So lets assume we are not doing all the changes in a single patch
set. Its too complex. You say the work queue should be in the
core. Lets put a work queue in the core to handle the blocking op, and
strip it out of the drivers. That allows you to get a lot of driver
patches merged.

You can then work on moving led_timer_function into the core, etc,
with a much smaller patch set, and hopefully in a number of small
steps which are easy to review.

      Andrew