Re: [PATCH 1/2] i2c: designware: register clkdev during acpi device configuration

[Mika Westerberg <mika.westerberg@linux.intel.com>]

On Wed, Oct 21, 2015 at 04:42:23PM +0800, Ken Xue wrote:
> On Wed, 2015-10-21 at 10:28 +0300, Mika Westerberg wrote:
> > On Wed, Oct 21, 2015 at 09:11:33AM +0800, Ken Xue wrote:
> > > On Tue, 2015-10-20 at 14:17 +0300, Mika Westerberg wrote:
> > > > On Tue, Oct 20, 2015 at 02:38:01PM +0800, Ken Xue wrote:
> > > > > DW I2C driver tries to register a clk from id->driver_data as an
> > > > > alternative way besides intel lpss. But code doesn't register the
> > > > > clk to clkdev. So, devm_clk_get will fail during probe.
> > > > > 
> > > > > The patch can fix this issue.
> > > > 
> > > > Since you now have drivers/acpi/acpi_apd.c for AMD ACPI stuff, can you
> > > > create the clock there just like we do for Intel stuff?
> > > Sure. APD already creates the clock for AMD0010 as you expected. And the
> > > next patch([PATCH 2/2] i2c: designware: remove freq definition for
> > > "AMD0010" in acpi_device_id) is dropping the old way for getting freq.
> > 
> > So this patch is not necessary, right?
> Even though there is no use case that getting freq from id->driver_data,
> But if we want to keep this design, then we should use current patch for
> fixing the potential issue. So, the patch is nice to have.

What potential issue?

If you pass clock from drivers/acpi/acpi_apd.c and drop the hard coded
freq for AMD0010 in the I2C designware driver, the driver still works
just fine.

> Otherwise, we have to revert whole old design(a445900c).

Yes please :-)