[U-Boot] [PATCH 3/3] colibri_vf: Add board_usb_phy_mode function

[Marek Vasut <marex@denx.de>]

On Monday, October 26, 2015 at 01:58:51 PM, Sanchayan Maity wrote:
> Add board_usb_phy_mode function for detecting whether a port is
> being used as host or client using a GPIO. On Colibri Vybrid we
> provide the GPIO 102 for the very same purpose.
> 
> Signed-off-by: Sanchayan Maity <maitysanchayan@gmail.com>
> ---
>  board/toradex/colibri_vf/colibri_vf.c | 19 ++++++++++++++++++-
>  1 file changed, 18 insertions(+), 1 deletion(-)
> 
> diff --git a/board/toradex/colibri_vf/colibri_vf.c
> b/board/toradex/colibri_vf/colibri_vf.c index a6d1c5b..fd90ef2 100644
> --- a/board/toradex/colibri_vf/colibri_vf.c
> +++ b/board/toradex/colibri_vf/colibri_vf.c
> @@ -34,6 +34,7 @@ DECLARE_GLOBAL_DATA_PTR;
>  			PAD_CTL_DSE_50ohm | PAD_CTL_OBE_IBE_ENABLE)
> 
>  #define USB_PEN_GPIO           83
> +#define USB_CDET_GPIO			102
> 
>  static struct ddrmc_cr_setting colibri_vf_cr_settings[] = {
>  	/* levelling */
> @@ -92,6 +93,7 @@ static struct ddrmc_cr_setting colibri_vf_cr_settings[] =
> {
> 
>  static const iomux_v3_cfg_t usb_pads[] = {
>  	VF610_PAD_PTD4__GPIO_83,
> +	VF610_PAD_PTC29__GPIO_102,
>  };
> 
>  int dram_init(void)
> @@ -280,7 +282,6 @@ static void setup_iomux_gpio(void)
>  		VF610_PAD_PTB23__GPIO_93,
>  		VF610_PAD_PTB26__GPIO_96,
>  		VF610_PAD_PTB28__GPIO_98,
> -		VF610_PAD_PTC29__GPIO_102,
>  		VF610_PAD_PTC30__GPIO_103,
>  		VF610_PAD_PTA7__GPIO_134,
>  	};
> @@ -554,4 +555,20 @@ int board_ehci_hcd_init(int port)
>  	}
>  	return 0;
>  }
> +
> +int board_usb_phy_mode(int port)
> +{
> +	switch (port) {
> +	case 0:
> +		gpio_request(USB_CDET_GPIO, "usb-cdet-gpio");

The gpio_request() here will fail the second time you do "usb reset" on
the command line I think. You might want to request this elsewhere.

> +		return gpio_get_value(USB_CDET_GPIO);
> +		break;
> +	case 1:
> +		return 0;
> +		break;
> +	default:
> +		return 0;
> +		break;
> +	}
> +}
>  #endif

Best regards,
Marek Vasut