From: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
To: linux-kernel@vger.kernel.org
Cc: Greg Kroah-Hartman <gregkh@linuxfoundation.org>,
stable@vger.kernel.org,
Soeren Grunewald <soeren.grunewald@desy.de>
Subject: [PATCH 3.14 36/37] serial: 8250_pci: Add support for 12 port Exar boards
Date: Fri, 6 Nov 2015 11:24:51 -0800 [thread overview]
Message-ID: <20151106192413.098362306@linuxfoundation.org> (raw)
In-Reply-To: <20151106192410.681850286@linuxfoundation.org>
3.14-stable review patch. If anyone has any objections, please let me know.
------------------
From: Soeren Grunewald <soeren.grunewald@desy.de>
commit be32c0cf0462c36f482b5ddcff1d8371be1e183c upstream.
The Exar XR17V358 can also be combined with a XR17V354 chip to act as a
single 12 port chip. This works the same way as the combining two XR17V358
chips. But the reported device id then is 0x4358.
Signed-off-by: Soeren Grunewald <soeren.grunewald@desy.de>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
---
drivers/tty/serial/8250/8250_pci.c | 21 +++++++++++++++++++++
1 file changed, 21 insertions(+)
--- a/drivers/tty/serial/8250/8250_pci.c
+++ b/drivers/tty/serial/8250/8250_pci.c
@@ -1772,6 +1772,7 @@ pci_wch_ch353_setup(struct serial_privat
#define PCI_DEVICE_ID_SUNIX_1999 0x1999
+#define PCI_DEVICE_ID_EXAR_XR17V4358 0x4358
#define PCI_DEVICE_ID_EXAR_XR17V8358 0x8358
/* Unknown vendors/cards - this should not be in linux/pci_ids.h */
@@ -2270,6 +2271,13 @@ static struct pci_serial_quirk pci_seria
},
{
.vendor = PCI_VENDOR_ID_EXAR,
+ .device = PCI_DEVICE_ID_EXAR_XR17V4358,
+ .subvendor = PCI_ANY_ID,
+ .subdevice = PCI_ANY_ID,
+ .setup = pci_xr17v35x_setup,
+ },
+ {
+ .vendor = PCI_VENDOR_ID_EXAR,
.device = PCI_DEVICE_ID_EXAR_XR17V8358,
.subvendor = PCI_ANY_ID,
.subdevice = PCI_ANY_ID,
@@ -2715,6 +2723,7 @@ enum pci_board_num_t {
pbn_exar_XR17V352,
pbn_exar_XR17V354,
pbn_exar_XR17V358,
+ pbn_exar_XR17V4358,
pbn_exar_XR17V8358,
pbn_exar_ibm_saturn,
pbn_pasemi_1682M,
@@ -3385,6 +3394,14 @@ static struct pciserial_board pci_boards
.reg_shift = 0,
.first_offset = 0,
},
+ [pbn_exar_XR17V4358] = {
+ .flags = FL_BASE0,
+ .num_ports = 12,
+ .base_baud = 7812500,
+ .uart_offset = 0x400,
+ .reg_shift = 0,
+ .first_offset = 0,
+ },
[pbn_exar_XR17V8358] = {
.flags = FL_BASE0,
.num_ports = 16,
@@ -4763,6 +4780,10 @@ static struct pci_device_id serial_pci_t
PCI_ANY_ID, PCI_ANY_ID,
0,
0, pbn_exar_XR17V358 },
+ { PCI_VENDOR_ID_EXAR, PCI_DEVICE_ID_EXAR_XR17V4358,
+ PCI_ANY_ID, PCI_ANY_ID,
+ 0,
+ 0, pbn_exar_XR17V4358 },
{ PCI_VENDOR_ID_EXAR, PCI_DEVICE_ID_EXAR_XR17V8358,
PCI_ANY_ID, PCI_ANY_ID,
0,
next prev parent reply other threads:[~2015-11-06 19:53 UTC|newest]
Thread overview: 38+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-11-06 19:24 [PATCH 3.14 00/37] 3.14.57-stable review Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 01/37] ath9k: declare required extra tx headroom Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 02/37] iwlwifi: dvm: fix D3 firmware PN programming Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 03/37] iwlwifi: fix firmware filename for 3160 Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 04/37] iwlwifi: mvm: fix D3 firmware PN programming Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 05/37] iwlwifi: pci: add a few more PCI subvendor IDs for the 7265 series Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 06/37] iommu/amd: Dont clear DTE flags when modifying it Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 07/37] powerpc/rtas: Validate rtas.entry before calling enter_rtas() Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 08/37] ASoC: wm8904: Correct number of EQ registers Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 09/37] x86/setup: Extend low identity map to cover whole kernel range Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 10/37] mm: make sendfile(2) killable Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 14/37] drm/nouveau/gem: return only valid domain when theres only one Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 16/37] drm/radeon: dont try to recreate sysfs entries on resume Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 18/37] rbd: require stable pages if message data CRCs are enabled Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 19/37] rbd: dont leak parent_spec in rbd_dev_probe_parent() Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 20/37] rbd: prevent kernel stack blow up on rbd map Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 21/37] Revert "ARM64: unwind: Fix PC calculation" Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 22/37] dm btree remove: fix a bug when rebalancing nodes after removal Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 23/37] dm btree: fix leak of bufio-backed block in btree_split_beneath error path Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 24/37] xhci: handle no ping response error properly Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 25/37] xhci: Add spurious wakeup quirk for LynxPoint-LP controllers Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 26/37] xen-blkfront: check for null drvdata in blkback_changed (XenbusStateClosing) Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 27/37] module: Fix locking in symbol_put_addr() Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 28/37] crypto: api - Only abort operations on fatal signal Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 29/37] md/raid1: submit_bio_wait() returns 0 on success Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 30/37] md/raid10: " Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 31/37] Revert "md: allow a partially recovered device to be hot-added to an array." Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 33/37] IB/cm: Fix rb-tree duplicate free and use-after-free Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 34/37] md/raid5: fix locking in handle_stripe_clean_event() Greg Kroah-Hartman
2015-11-06 19:24 ` [PATCH 3.14 35/37] serial: 8250_pci: Add support for 16 port Exar boards Greg Kroah-Hartman
2015-11-23 14:23 ` Soeren Grunewald
2016-02-23 23:51 ` Greg Kroah-Hartman
2015-11-06 19:24 ` Greg Kroah-Hartman [this message]
2015-11-06 19:24 ` [PATCH 3.14 37/37] xen: fix backport of previous kexec patch Greg Kroah-Hartman
2015-11-07 1:41 ` [PATCH 3.14 00/37] 3.14.57-stable review Guenter Roeck
2015-11-07 2:54 ` Shuah Khan
[not found] ` <56402111.42371c0a.e127c.749b@mx.google.com>
2015-11-09 4:41 ` Kevin Hilman
2015-11-09 17:09 ` Greg Kroah-Hartman
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20151106192413.098362306@linuxfoundation.org \
--to=gregkh@linuxfoundation.org \
--cc=linux-kernel@vger.kernel.org \
--cc=soeren.grunewald@desy.de \
--cc=stable@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.