From mboxrd@z Thu Jan 1 00:00:00 1970 Date: Mon, 15 Feb 2016 14:44:37 +0100 From: Gilles Chanteperdrix Message-ID: <20160215134437.GE9903@hermes.click-hack.org> References: <20160215125941.GD9903@hermes.click-hack.org> MIME-Version: 1.0 Content-Type: text/plain; charset=us-ascii Content-Disposition: inline In-Reply-To: Subject: Re: [Xenomai] Problem with rt_igb driver for I210 card List-Id: Discussions about the Xenomai project List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , To: "GEORGE, Laurent" Cc: xenomai@xenomai.org On Mon, Feb 15, 2016 at 02:37:23PM +0100, GEORGE, Laurent wrote: > >"It does not work" is a bit vague. Do you wait for the link to be up > >before sending the solicit? Does it return an error? Does it > >send a packet but receive no answer? Some other case? > > Some precisions on the problem: > > 1) I load all the required modules (like rtnet, rt_igb, etc)- No error > 2) I make the rteth0 interface up - No error > 3) rtifconfig -a shows rteth0 interface - No error > 4) I then run ./rtroute solicit ip_address dev rteth0 - No Error > 5) I then check whether the device is solicited using ./rtroute - Error (It > doesn't show that IP which I had just solicited - In normal Conditions, it > shows when there is no error) Ok, but on the other side, do you see the ARP packet, or not? If yes, does the other side answer or not? Do the TX and RX packet counters increase? -- Gilles. https://click-hack.org