From mboxrd@z Thu Jan 1 00:00:00 1970 Return-path: Received: from mail-io0-x236.google.com ([2607:f8b0:4001:c06::236]) by bombadil.infradead.org with esmtps (Exim 4.80.1 #2 (Red Hat Linux)) id 1ayUe5-0001ct-G9 for ath10k@lists.infradead.org; Fri, 06 May 2016 01:33:34 +0000 Received: by mail-io0-x236.google.com with SMTP id u185so117190256iod.3 for ; Thu, 05 May 2016 18:33:10 -0700 (PDT) Date: Thu, 5 May 2016 21:32:52 -0400 From: Bob Copeland Subject: Re: 802.11s channel width settings? Message-ID: <20160506013252.GB28948@localhost> References: MIME-Version: 1.0 Content-Disposition: inline In-Reply-To: List-Id: List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit Sender: "ath10k" Errors-To: ath10k-bounces+kvalo=adurom.com@lists.infradead.org To: Zach Sherin Cc: ath10k@lists.infradead.org On Thu, May 05, 2016 at 02:51:27PM -0400, Zach Sherin wrote: > Is there any way to increase channel widths in 802.11s? If this is an > OpenWRT question and not ath10k I'll head over to the forums, but this > seemed more a driver issue as my wireless config requests wide > channels. Any chance there's a specific version of ath10k I should > push to? I'm not sure about OpenWRT's scripts but you can specify the channel width when setting the frequency (before joining the mesh). E.g.: ip link set wlan0 up iw dev wlan0 set freq 5745 80 5775 iw dev wlan0 mesh join my-vht-mesh -- Bob Copeland %% http://bobcopeland.com/ _______________________________________________ ath10k mailing list ath10k@lists.infradead.org http://lists.infradead.org/mailman/listinfo/ath10k