Re: [PATCH v2 net-next v2 12/12] net: dsa: mv88e6xxx: add addressing mode to info

[Andrew Lunn <andrew@lunn.ch>]

On Tue, Jun 14, 2016 at 06:24:17PM -0400, Vivien Didelot wrote:
> Hi Andrew,
> 
> Andrew Lunn <andrew@lunn.ch> writes:
> 
> >> -	ret = mdiobus_read_nested(bus, addr, reg);
> >> +	ret = mdiobus_read_nested(bus, sw_addr + addr, reg);
> >>  	if (ret < 0)
> >>  		return ret;
> >
> > If we are doing direct access, doesn't it means sw_addr is 0?
> >
> > So isn't this pointless?
> 
> 6060 has no indirect access and directly responds to 16 SMI addresses,
> regardless its chip address which can be strapped to either 0 or 16.

Ah! O.K.

wnr854t-setup.c uses 0.
rd88f6183ap-ge-setup.c uses 0.
wrt350n-v2-setup.c uses 0.
rd88f5181l-fxo-setup.c uses 0.
rd88f5181l-ge-setup.c uses 0.
mach-bf518/boards/ezbrd.c uses 0.

The 6060 is a very old device. I doubt we will get any new boards
contributed using it. We are also going to have trouble actually
finding a device with one in order to test a merged mv88e6xxx and
mv88e6060 driver.

So i say we ignore the possibility of an 6060 on 16, until one really
comes along.

> Question 2) is MV88E6XXX_FLAG_MULTI_CHIP confusing?

No, i think it is fine.

    Andrew