Re: [PATCH 3/5] kbuild: add arch specific post-module-link pass

[Sam Ravnborg <sam@ravnborg.org>]

On Fri, Aug 05, 2016 at 10:12:01PM +1000, Nicholas Piggin wrote:
> Add an option for architectures to pass over modules after they are
> linked. powerpc will use this to fix up alternate instruction patch
> relocations.
> 
> Signed-off-by: Nicholas Piggin <npiggin@gmail.com>
> ---
>  Documentation/kbuild/makefiles.txt | 6 ++++++
>  Makefile                           | 1 +
>  scripts/Makefile.modpost           | 8 ++++++++
>  3 files changed, 15 insertions(+)
> 
> diff --git a/Documentation/kbuild/makefiles.txt b/Documentation/kbuild/makefiles.txt
> index 13f888a..f6c065b 100644
> --- a/Documentation/kbuild/makefiles.txt
> +++ b/Documentation/kbuild/makefiles.txt
> @@ -952,6 +952,12 @@ When kbuild executes, the following steps are followed (roughly):
>  	$(KBUILD_ARFLAGS) set by the top level Makefile to "D" (deterministic
>  	mode) if this option is supported by $(AR).
>  
> +    KBUILD_MODPOST_TOOL   Arch-specific command to run after module link
> +
> +        $(KBUILD_MODPOST_TOOL) is used to add an arch-specific pass over
> +        modules after their final link. E.g., powerpc uses this to adjust
> +        relative branches of "alternate code patching" sections.
> +

This needs documentation in kbuild.txt, where there is a
nearly full lst of KBUILD_ variables.

	Sam