Re: [PATCH 2/4] net: phy: Add MAC-IF driver for Microsemi PHYs.

[Raju Lakkaraju <Raju.Lakkaraju@microsemi.com>]

Hi Andrew,

Thank you for review the code and valuable comments.
I accepted your review comments.
I will re-send the code.

Thanks,
Raju.

On Wed, Aug 24, 2016 at 03:06:44PM +0200, Andrew Lunn wrote:
> EXTERNAL EMAIL
> 
> 
> > +static int vsc85xx_mac_if_set(struct phy_device *phydev,
> > +                             phy_interface_t   *interface)
> > +{
> > +       int rc;
> > +       u16 reg_val;
> > +
> > +       mutex_lock(&phydev->lock);
> > +       reg_val = phy_read(phydev, MSCC_PHY_EXT_PHY_CNTL_1);
> > +       switch (*interface) {
> > +       case PHY_INTERFACE_MODE_RGMII:
> > +               reg_val &= ~(MAC_IF_SELECTION_MASK);
> > +               reg_val |= (MAC_IF_SELECTION_RGMII << MAC_IF_SELECTION_POS);
> > +               break;
> > +       case PHY_INTERFACE_MODE_RMII:
> > +               reg_val &= ~(MAC_IF_SELECTION_MASK);
> > +               reg_val |= (MAC_IF_SELECTION_RMII << MAC_IF_SELECTION_POS);
> > +               break;
> > +       case PHY_INTERFACE_MODE_MII:
> > +       case PHY_INTERFACE_MODE_GMII:
> > +       default:
> > +               reg_val &= ~(MAC_IF_SELECTION_MASK);
> > +               reg_val |= (MAC_IF_SELECTION_GMII << MAC_IF_SELECTION_POS);
> > +               break;
> > +       }
> > +       rc = phy_write(phydev, MSCC_PHY_EXT_PHY_CNTL_1, reg_val);
> > +       if (rc != 0)
> > +               goto out_unlock;
> > +
> > +       rc = vsc85xx_soft_reset(phydev);
> > +
> > +out_unlock:
> > +       mutex_unlock(&phydev->lock);
> > +
> > +       return rc;
> > +}
> 
> Again, you need to justify why you are doing something completely
> different to all other phy drivers. You cannot you do what
> m88e1121_config_aneg(), mv88e111_config_init(), dp83867_config_init()
> does?
> 
>         Andrew