Re: [PATCH net-next 2/2] net: phy: Add PHY Auto/Mdi/Mdix set driver for Microsemi PHYs.

[Raju Lakkaraju <Raju.Lakkaraju@microsemi.com>]

Hi Florian/Andrew,

Thank you for review comments.

On Thu, Oct 06, 2016 at 03:57:32AM -0700, Florian Fainelli wrote:
> EXTERNAL EMAIL
> 
> 
> On 09/28/2016 01:24 PM, Andrew Lunn wrote:
> >>  static int vsc85xx_wol_set(struct phy_device *phydev,
> >>                         struct ethtool_wolinfo *wol)
> >>  {
> >> @@ -227,6 +281,7 @@ static int vsc85xx_default_config(struct phy_device *phydev)
> >>      int rc;
> >>      u16 reg_val;
> >>
> >> +    phydev->mdix = ETH_TP_MDI_AUTO;
> >
> > Humm, interesting. The only other driver supporting mdix is the
> > Marvell one. It does not do this, it leaves it to its default value of
> > ETH_TP_MDI_INVALID. It does however interpret ETH_TP_MDI_INVALID as
> > meaning as ETH_TP_MDI_AUTO.
> >
> > There needs to be consistency here. You either need to do the same as
> > the Marvell driver, or you need to modify the Marvell driver to also
> > set phydev->mdix to ETH_TP_MDI_AUTO.
> >
> > I don't yet know which of these two is the right thing to do.
> >
> > Florian?
> 
> It's really hard to tell because the other drivers I looked at do not
> necessarily seem to be consistent either. Here, if the MDI status is
> really auto, then this is the correct value to return, if it is unknown,
> it should be ETH_TP_MDI_INVALID.
> 

In mdix get status function, This value will be update as per 
PHY mdix current status.

Shall i configure "phydev->mdix = ETH_TP_MDI_AUTO" as default ?

Andrew, do you have any comments?

> For the Marvell PHY, it sounds like we should be able to determine what
> was configured and return the correct MDI status value
> --
> Florian

---
Thanks,
Raju.