[Intel-wired-lan] [RFC PATCH 16/20] ixgbe: Use length to determine if descriptor is done

[Alexander Duyck <alexander.duyck@gmail.com>]

From: Alexander Duyck <alexander.h.duyck@intel.com>

This change makes it so that we use the length of the packet instead of the
DD status bit to determine if a new descriptor is ready to be processed.
The obvious advantage is that it cuts down on reads as we don't really even
need the DD bit if going from a 0 to a non-zero value on size is enough to
inform us that the packet has been completed.

Signed-off-by: Alexander Duyck <alexander.h.duyck@intel.com>
---
 drivers/net/ethernet/intel/ixgbe/ixgbe_main.c |    6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c b/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c
index 56a2408ac0d8..abd68b9b628e 100644
--- a/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c
+++ b/drivers/net/ethernet/intel/ixgbe/ixgbe_main.c
@@ -1637,8 +1637,8 @@ void ixgbe_alloc_rx_buffers(struct ixgbe_ring *rx_ring, u16 cleaned_count)
 			i -= rx_ring->count;
 		}
 
-		/* clear the status bits for the next_to_use descriptor */
-		rx_desc->wb.upper.status_error = 0;
+		/* clear the length for the next_to_use descriptor */
+		rx_desc->wb.upper.length = 0;
 
 		cleaned_count--;
 	} while (cleaned_count);
@@ -2154,7 +2154,7 @@ static int ixgbe_clean_rx_irq(struct ixgbe_q_vector *q_vector,
 
 		rx_desc = IXGBE_RX_DESC(rx_ring, rx_ring->next_to_clean);
 
-		if (!rx_desc->wb.upper.status_error)
+		if (!rx_desc->wb.upper.length)
 			break;
 
 		/* This memory barrier is needed to keep us from reading