From: "Dr. David Alan Gilbert (git)" <dgilbert@redhat.com>
To: qemu-devel@nongnu.org, quintela@redhat.com, amit.shah@redhat.com
Cc: aarcange@redhat.com
Subject: [Qemu-devel] [PATCH 03/15] postcopy: Chunk discards for hugepages
Date: Fri, 6 Jan 2017 18:28:11 +0000 [thread overview]
Message-ID: <20170106182823.1960-4-dgilbert@redhat.com> (raw)
In-Reply-To: <20170106182823.1960-1-dgilbert@redhat.com>
From: "Dr. David Alan Gilbert" <dgilbert@redhat.com>
At the start of the postcopy phase, partially sent huge pages
must be discarded. The code for dealing with host page sizes larger
than the target page size can be reused for this case.
Signed-off-by: Dr. David Alan Gilbert <dgilbert@redhat.com>
---
migration/ram.c | 17 +++++++++--------
1 file changed, 9 insertions(+), 8 deletions(-)
diff --git a/migration/ram.c b/migration/ram.c
index 40fe888..c9d8290 100644
--- a/migration/ram.c
+++ b/migration/ram.c
@@ -1635,12 +1635,17 @@ static void postcopy_chunk_hostpages_pass(MigrationState *ms, bool unsent_pass,
{
unsigned long *bitmap;
unsigned long *unsentmap;
- unsigned int host_ratio = qemu_host_page_size / TARGET_PAGE_SIZE;
+ unsigned int host_ratio = block->page_size / TARGET_PAGE_SIZE;
unsigned long first = block->offset >> TARGET_PAGE_BITS;
unsigned long len = block->used_length >> TARGET_PAGE_BITS;
unsigned long last = first + (len - 1);
unsigned long run_start;
+ if (block->page_size == TARGET_PAGE_SIZE) {
+ /* Easy case - TPS==HPS for a non-huge page RAMBlock */
+ return;
+ }
+
bitmap = atomic_rcu_read(&migration_bitmap_rcu)->bmap;
unsentmap = atomic_rcu_read(&migration_bitmap_rcu)->unsentmap;
@@ -1744,7 +1749,8 @@ static void postcopy_chunk_hostpages_pass(MigrationState *ms, bool unsent_pass,
* Utility for the outgoing postcopy code.
*
* Discard any partially sent host-page size chunks, mark any partially
- * dirty host-page size chunks as all dirty.
+ * dirty host-page size chunks as all dirty. In this case the host-page
+ * is the host-page for the particular RAMBlock, i.e. it might be a huge page
*
* Returns: 0 on success
*/
@@ -1752,11 +1758,6 @@ static int postcopy_chunk_hostpages(MigrationState *ms)
{
struct RAMBlock *block;
- if (qemu_host_page_size == TARGET_PAGE_SIZE) {
- /* Easy case - TPS==HPS - nothing to be done */
- return 0;
- }
-
/* Easiest way to make sure we don't resume in the middle of a host-page */
last_seen_block = NULL;
last_sent_block = NULL;
@@ -1812,7 +1813,7 @@ int ram_postcopy_send_discard_bitmap(MigrationState *ms)
return -EINVAL;
}
- /* Deal with TPS != HPS */
+ /* Deal with TPS != HPS and huge pages */
ret = postcopy_chunk_hostpages(ms);
if (ret) {
rcu_read_unlock();
--
2.9.3
next prev parent reply other threads:[~2017-01-06 18:28 UTC|newest]
Thread overview: 47+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-01-06 18:28 [Qemu-devel] [PATCH 00/15] Postcopy: Hugepage support Dr. David Alan Gilbert (git)
2017-01-06 18:28 ` [Qemu-devel] [PATCH 01/15] postcopy: Transmit and compare individual page sizes Dr. David Alan Gilbert (git)
2017-01-25 8:01 ` [Qemu-devel] [01/15] " Alexey Perevalov
2017-01-25 18:38 ` Dr. David Alan Gilbert
2017-01-25 9:47 ` [Qemu-devel] [PATCH 01/15] " Juan Quintela
2017-01-25 16:15 ` Dr. David Alan Gilbert
2017-01-06 18:28 ` [Qemu-devel] [PATCH 02/15] postcopy: Transmit ram size summary word Dr. David Alan Gilbert (git)
2017-01-25 9:53 ` Juan Quintela
2017-01-25 16:18 ` Dr. David Alan Gilbert
2017-01-06 18:28 ` Dr. David Alan Gilbert (git) [this message]
2017-01-25 10:44 ` [Qemu-devel] [PATCH 03/15] postcopy: Chunk discards for hugepages Juan Quintela
2017-01-06 18:28 ` [Qemu-devel] [PATCH 04/15] Fold postcopy_ram_discard_range into ram_discard_range Dr. David Alan Gilbert (git)
2017-01-25 10:08 ` Juan Quintela
2017-01-25 16:43 ` Dr. David Alan Gilbert
2017-01-06 18:28 ` [Qemu-devel] [PATCH 05/15] postcopy: enhance ram_discard_range for hugepages Dr. David Alan Gilbert (git)
2017-01-25 10:14 ` Juan Quintela
2017-01-30 18:49 ` Dr. David Alan Gilbert
2017-01-30 19:19 ` Juan Quintela
2017-01-06 18:28 ` [Qemu-devel] [PATCH 06/15] postcopy: Record largest page size Dr. David Alan Gilbert (git)
2017-01-25 10:17 ` Juan Quintela
2017-01-30 16:36 ` Dr. David Alan Gilbert
2017-01-30 19:22 ` Juan Quintela
2017-01-06 18:28 ` [Qemu-devel] [PATCH 07/15] postcopy: Plumb pagesize down into place helpers Dr. David Alan Gilbert (git)
2017-01-25 10:25 ` Juan Quintela
2017-01-27 15:49 ` Dr. David Alan Gilbert
2017-01-06 18:28 ` [Qemu-devel] [PATCH 08/15] postcopy: Use temporary for placing zero huge pages Dr. David Alan Gilbert (git)
2017-01-25 10:29 ` Juan Quintela
2017-01-06 18:28 ` [Qemu-devel] [PATCH 09/15] postcopy: Load huge pages in one go Dr. David Alan Gilbert (git)
2017-01-25 10:31 ` Juan Quintela
2017-01-06 18:28 ` [Qemu-devel] [PATCH 10/15] postcopy: Mask fault addresses to huge page boundary Dr. David Alan Gilbert (git)
2017-01-31 13:20 ` Juan Quintela
2017-01-06 18:28 ` [Qemu-devel] [PATCH 11/15] postcopy: Send whole huge pages Dr. David Alan Gilbert (git)
2017-01-31 13:20 ` Juan Quintela
2017-01-06 18:28 ` [Qemu-devel] [PATCH 12/15] postcopy: Allow hugepages Dr. David Alan Gilbert (git)
2017-01-31 13:21 ` Juan Quintela
2017-01-06 18:28 ` [Qemu-devel] [PATCH 13/15] postcopy: Update userfaultfd.h header Dr. David Alan Gilbert (git)
2017-01-31 13:22 ` Juan Quintela
2017-01-06 18:28 ` [Qemu-devel] [PATCH 14/15] postcopy: Check for userfault+hugepage feature Dr. David Alan Gilbert (git)
2017-01-31 13:24 ` Juan Quintela
2017-01-31 16:20 ` Dr. David Alan Gilbert
2017-01-06 18:28 ` [Qemu-devel] [PATCH 15/15] postcopy: Add doc about hugepages and postcopy Dr. David Alan Gilbert (git)
2017-01-31 13:25 ` Juan Quintela
2017-01-06 18:51 ` [Qemu-devel] [PATCH 00/15] Postcopy: Hugepage support no-reply
2017-01-06 18:59 ` Dr. David Alan Gilbert
2017-01-09 0:55 ` Fam Zheng
2017-01-09 9:03 ` Dr. David Alan Gilbert
2017-01-06 19:02 ` no-reply
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20170106182823.1960-4-dgilbert@redhat.com \
--to=dgilbert@redhat.com \
--cc=aarcange@redhat.com \
--cc=amit.shah@redhat.com \
--cc=qemu-devel@nongnu.org \
--cc=quintela@redhat.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.