From mboxrd@z Thu Jan 1 00:00:00 1970 From: Peng Fan Date: Tue, 9 May 2017 10:39:21 +0800 Subject: [U-Boot] [PATCH 06/17] mx6ul_14x14_evk: Fix unused variable warning In-Reply-To: <1494296075-29477-6-git-send-email-trini@konsulko.com> References: <1494296075-29477-1-git-send-email-trini@konsulko.com> <1494296075-29477-6-git-send-email-trini@konsulko.com> Message-ID: <20170509023918.GB28300@linux-7smt.suse> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: u-boot@lists.denx.de On Mon, May 08, 2017 at 10:14:24PM -0400, Tom Rini wrote: >The variable usdhc1_pads is only referenced during SPL builds, add a guard. > >Cc: Stefano Babic >Cc: Peng Fan >Signed-off-by: Tom Rini Reviewed-by: Peng Fan >--- > board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c | 2 ++ > 1 file changed, 2 insertions(+) > >diff --git a/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c b/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c >index b28ce1049589..a5746fe08688 100644 >--- a/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c >+++ b/board/freescale/mx6ul_14x14_evk/mx6ul_14x14_evk.c >@@ -225,6 +225,7 @@ static iomux_v3_cfg_t const uart1_pads[] = { > MX6_PAD_UART1_RX_DATA__UART1_DCE_RX | MUX_PAD_CTRL(UART_PAD_CTRL), > }; > >+#ifndef CONFIG_SPL_BUILD > static iomux_v3_cfg_t const usdhc1_pads[] = { > MX6_PAD_SD1_CLK__USDHC1_CLK | MUX_PAD_CTRL(USDHC_PAD_CTRL), > MX6_PAD_SD1_CMD__USDHC1_CMD | MUX_PAD_CTRL(USDHC_PAD_CTRL), >@@ -240,6 +241,7 @@ static iomux_v3_cfg_t const usdhc1_pads[] = { > /* RST_B */ > MX6_PAD_GPIO1_IO09__GPIO1_IO09 | MUX_PAD_CTRL(NO_PAD_CTRL), > }; >+#endif > > /* > * mx6ul_14x14_evk board default supports sd card. If want to use >-- >1.9.1 > >_______________________________________________ >U-Boot mailing list >U-Boot at lists.denx.de >https://lists.denx.de/listinfo/u-boot