Re: [PATCH net-next 6/9] net: hns3: Add MDIO support to HNS3 Ethernet driver for hip08 SoC

[Andrew Lunn <andrew@lunn.ch>]

> > +int hclge_mac_mdio_config(struct hclge_dev *hdev)
> > +{
> > +	struct hclge_mac *mac = &hdev->hw.mac;
> > +	struct mii_bus *mdio_bus;
> > +	struct net_device *ndev = &mac->ndev;
> > +	struct phy_device *phy;
> > +	bool is_c45;
> > +	int ret;
> > +
> > +	if (hdev->hw.mac.phy_addr >= PHY_MAX_ADDR)
> > +		return 0;
> > +
> > +	if (hdev->hw.mac.phy_if == PHY_INTERFACE_MODE_NA)
> > +		return 0;
> > +	else if (mac->phy_if == PHY_INTERFACE_MODE_SGMII)
> > +		is_c45 = 0;
> > +	else if (mac->phy_if == PHY_INTERFACE_MODE_XGMII)
> > +		is_c45 = 1;
> > +	else
> > +		return -ENODATA;
> 
> Can you consider using a switch () case statement here?

Does this concept even make sense? The Marvell 10G phy will use SGMII
for 10/100/1000Mbs and swap to XGMII for 10Gbps. It however stays a
c45 device all the time.

In general, i don't think PHY mode is related to C22/C45.

   Andrew