Re: [PATCH v2] dmaengine: fsl-edma: disable clks on all error paths

[Vinod Koul <vinod.koul@intel.com>]

On Wed, Dec 06, 2017 at 02:50:23PM +0100, Andreas Platschek wrote:
> Previously enabled clks are only disabled if clk_prepare_enable() fails.
> However, there are other error paths were the previously enabled
> clocks are not disabled.
> 
> Found by Linux Driver Verification project (linuxtesting.org).
> 
> Signed-off-by: Andreas Platschek <andreas.platschek@opentech.at>
> ---
>  drivers/dma/fsl-edma.c | 13 +++++++++++--
>  1 file changed, 11 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/dma/fsl-edma.c b/drivers/dma/fsl-edma.c
> index 6775f2c74e25..9940f2f7039f 100644
> --- a/drivers/dma/fsl-edma.c
> +++ b/drivers/dma/fsl-edma.c
> @@ -878,7 +878,7 @@ static int fsl_edma_probe(struct platform_device *pdev)
>  	struct fsl_edma_chan *fsl_chan;
>  	struct resource *res;
>  	int len, chans;
> -	int ret, i;
> +	int ret, i, j;
>  
>  	ret = of_property_read_u32(np, "dma-channels", &chans);
>  	if (ret) {
> @@ -904,12 +904,21 @@ static int fsl_edma_probe(struct platform_device *pdev)
>  
>  		res = platform_get_resource(pdev, IORESOURCE_MEM, 1 + i);
>  		fsl_edma->muxbase[i] = devm_ioremap_resource(&pdev->dev, res);
> -		if (IS_ERR(fsl_edma->muxbase[i]))
> +		if (IS_ERR(fsl_edma->muxbase[i])) {
> +			/* disable only clks which were enabled on error */
> +			for (j = i-1; j >= 0; j--)
				^^^
space around - pls
> +				clk_disable_unprepare(fsl_edma->muxclk[j]);

why not modify fsl_disable_clocks() and invoke that...?

>  
>  		sprintf(clkname, "dmamux%d", i);
>  		fsl_edma->muxclk[i] = devm_clk_get(&pdev->dev, clkname);
>  		if (IS_ERR(fsl_edma->muxclk[i])) {
> +			/* disable only clks which were enabled on error */
> +			for (j = i-1; j >= 0; j--)
> +				clk_disable_unprepare(fsl_edma->muxclk[j]);

ditto

-- 
~Vinod