Re: [PATCH v5 01/18] PCI: dwc: Use the DMA-API to get the MSI address

[Niklas Cassel <niklas.cassel@axis.com>]

On Tue, Dec 19, 2017 at 12:45:30PM +0000, Gustavo Pimentel wrote:
> Tested-By: Gustavo Pimentel <gustavo.pimentel@synopsys.com>
> 
> Using an arc board with USB and SATA end points with a root complex PCIe IP core
> version 5.00, I ran the the following tests:
>  - I checked that all end points were listed correctly;
>  - I checked that no PCI related errors was present in dmesg;
>  - I copied a file from arc to the USB flash drive and checked the checksum;
>  - I copied a file from USB flash drive to the ARC and checked the checksum;
>  - I copied a file from arc to the SATA disk and checked the checksum;
>  - I copied a file from SATA disk to the arc and checked the checksum;
>  - I copied a file from USB flash drive to the SATA disk and checked the checksum;
>  - I copied a file from SATA disk to the USB flash drive and checked the checksum;
>  - I checked that no PCI related errors was present in dmesg;
> 
> Everything seemed normal to me.

Hello Gustavo,

Thanks a lot for testing.

FYI: I submitted a new patch set to address Lorenzo's review comments,
however, I do not think that we need to redo all the testing, since
now we are using the same GFP flags for MSI as we did before, which
obviously worked.

https://marc.info/?l=devicetree&m=151372652827788&w=2

Regards,
Niklas