Re: [Qemu-devel] vhost-user graceful connect/disconnect

[Fam Zheng <famz@redhat.com>]

On Tue, 12/19 16:21, Stefan Hajnoczi wrote:
> Hi,
> Vhost-user implementations assume the slave is already running before
> the master starts.  The slave is required during virtio device
> initialization (e.g. feature bit negotiation) and so it is simplest to
> assume that the master is already available and will respond immediately
> to the VHOST_USER_GET_FEATURES message.
> 
> I have thought about how to let master and slave start in any order.
> Some approaches involve changes to the VIRTIO specification so that
> guest drivers can wait until the vhost-user connection is established.
> 
> We can avoid spec changes using PCI hotplug:
> 
> 1. Introduce a new vhost-user object that manages a connection:
> 
>    -chardev ...
>    -object vhost-user,id=vhost-user0,chardev=chr0
> 
>    Note this object is *not* a NetClient.  It's a resource for managing
>    a vhost-user connection and can be used with any device type (net,
>    scsi, blk, etc).
> 
>    This object tries to establish a connection.  When a connection is
>    established it sends vhost-user protocol messages to fetch
>    information needed for virtio device initialization (like the number
>    of virtqueues supported, features bits, etc).  This information is
>    stashed so that vhost_*() calls later on do not require synchronous
>    communication with the vhost-user slave.
> 
> 2. When the vhost-user connection is established the object emits a QMP
>    event so management software can hotplug the virtio device:
> 
>    VHOST_USER_CONNECTED source=vhost-user0
> 
> 3. The management software hotplugs the virtio device:
> 
>    (qmp) netdev_add vhost-user,id=netdev0,vhost-user=vhost-user0
>    (qmp) device_add virtio-net-pci,netdev=netdev0

Why cannot the management software start the slave then hot plug chardev +
netdev + virtio-net-pci? That way we don't need the vhost-user connected event.

Fam