Re: [PATCH v3 1/2] dt-bindings: add bindings doc for HiSilicon INNO USB2 PHY

[Shawn Guo <shawn.guo@linaro.org>]

On Fri, Mar 02, 2018 at 01:35:43PM +0530, Kishon Vijay Abraham I wrote:
> >>> diff --git a/Documentation/devicetree/bindings/phy/phy-hisi-inno-usb2.txt b/Documentation/devicetree/bindings/phy/phy-hisi-inno-usb2.txt
> >>> new file mode 100644
> >>> index 000000000000..b563cf54ca7b
> >>> --- /dev/null
> >>> +++ b/Documentation/devicetree/bindings/phy/phy-hisi-inno-usb2.txt
> >>> @@ -0,0 +1,52 @@
> >>> +HiSilicon INNO USB2 PHY
> >>> +
> >>> +Required properties:
> >>> +- compatible: Should be one of the following strings:
> >>> +	"hisilicon,inno-usb2-phy",
> >>> +	"hisilicon,hi3798cv200-usb2-phy".
> >>> +- reg: Should be the address space for PHY configuration register in peripheral
> >>> +  controller, e.g. PERI_USB0 for USB 2.0 PHY01 on Hi3798cv200 SoC.
> >>> +- #phy-cells: Should be 1. The specifier is the index of the PHY port to
> >>> +  reference.
> >>
> >> This can be '0' if the consumers directly use phandle to the subnodes.
> > 
> > Yes, I understand that for most of PHY devices #phy-cells is just 0, and
> > consumers simply use the phandle without any cell number.  But for this
> > inno-usb2-phy, every single device contains two PHY ports, and each port
> 
> Why not have a separate sub-node for each phy port? Then you can just use
> phandle to the subnode in the controller node.

It sounds like a sensible suggestion.  I will try to implement that and
see how it goes.  Thanks.

Shawn