From: David Ahern <dsahern@gmail.com>
To: netdev@vger.kernel.org
Cc: idosch@idosch.org, David Ahern <dsahern@gmail.com>
Subject: [PATCH v3 net-next 1/5] net/ipv6: Refactor gateway validation on route add
Date: Tue, 6 Mar 2018 19:58:37 -0800 [thread overview]
Message-ID: <20180307035841.774-2-dsahern@gmail.com> (raw)
In-Reply-To: <20180307035841.774-1-dsahern@gmail.com>
Move gateway validation code from ip6_route_info_create into
ip6_validate_gw. Code move plus adjustments to handle the potential
reset of dev and idev and to make checkpatch happy.
Signed-off-by: David Ahern <dsahern@gmail.com>
---
net/ipv6/route.c | 120 ++++++++++++++++++++++++++++++-------------------------
1 file changed, 66 insertions(+), 54 deletions(-)
diff --git a/net/ipv6/route.c b/net/ipv6/route.c
index f0ae58424c45..3851c3ccfd7a 100644
--- a/net/ipv6/route.c
+++ b/net/ipv6/route.c
@@ -2550,7 +2550,7 @@ static struct rt6_info *ip6_nh_lookup_table(struct net *net,
static int ip6_route_check_nh_onlink(struct net *net,
struct fib6_config *cfg,
- struct net_device *dev,
+ const struct net_device *dev,
struct netlink_ext_ack *extack)
{
u32 tbid = l3mdev_fib_table(dev) ? : RT_TABLE_MAIN;
@@ -2626,6 +2626,68 @@ static int ip6_route_check_nh(struct net *net,
return err;
}
+static int ip6_validate_gw(struct net *net, struct fib6_config *cfg,
+ struct net_device **_dev, struct inet6_dev **idev,
+ struct netlink_ext_ack *extack)
+{
+ const struct in6_addr *gw_addr = &cfg->fc_gateway;
+ int gwa_type = ipv6_addr_type(gw_addr);
+ const struct net_device *dev = *_dev;
+ int err = -EINVAL;
+
+ /* if gw_addr is local we will fail to detect this in case
+ * address is still TENTATIVE (DAD in progress). rt6_lookup()
+ * will return already-added prefix route via interface that
+ * prefix route was assigned to, which might be non-loopback.
+ */
+ if (ipv6_chk_addr_and_flags(net, gw_addr,
+ gwa_type & IPV6_ADDR_LINKLOCAL ?
+ dev : NULL, 0, 0)) {
+ NL_SET_ERR_MSG(extack, "Invalid gateway address");
+ goto out;
+ }
+
+ if (gwa_type != (IPV6_ADDR_LINKLOCAL | IPV6_ADDR_UNICAST)) {
+ /* IPv6 strictly inhibits using not link-local
+ * addresses as nexthop address.
+ * Otherwise, router will not able to send redirects.
+ * It is very good, but in some (rare!) circumstances
+ * (SIT, PtP, NBMA NOARP links) it is handy to allow
+ * some exceptions. --ANK
+ * We allow IPv4-mapped nexthops to support RFC4798-type
+ * addressing
+ */
+ if (!(gwa_type & (IPV6_ADDR_UNICAST | IPV6_ADDR_MAPPED))) {
+ NL_SET_ERR_MSG(extack, "Invalid gateway address");
+ goto out;
+ }
+
+ if (cfg->fc_flags & RTNH_F_ONLINK)
+ err = ip6_route_check_nh_onlink(net, cfg, dev, extack);
+ else
+ err = ip6_route_check_nh(net, cfg, _dev, idev);
+
+ if (err)
+ goto out;
+ }
+
+ /* reload in case device was changed */
+ dev = *_dev;
+
+ err = -EINVAL;
+ if (!dev) {
+ NL_SET_ERR_MSG(extack, "Egress device not specified");
+ goto out;
+ } else if (dev->flags & IFF_LOOPBACK) {
+ NL_SET_ERR_MSG(extack,
+ "Egress device can not be loopback device for this route");
+ goto out;
+ }
+ err = 0;
+out:
+ return err;
+}
+
static struct rt6_info *ip6_route_info_create(struct fib6_config *cfg,
struct netlink_ext_ack *extack)
{
@@ -2808,61 +2870,11 @@ static struct rt6_info *ip6_route_info_create(struct fib6_config *cfg,
}
if (cfg->fc_flags & RTF_GATEWAY) {
- const struct in6_addr *gw_addr;
- int gwa_type;
-
- gw_addr = &cfg->fc_gateway;
- gwa_type = ipv6_addr_type(gw_addr);
-
- /* if gw_addr is local we will fail to detect this in case
- * address is still TENTATIVE (DAD in progress). rt6_lookup()
- * will return already-added prefix route via interface that
- * prefix route was assigned to, which might be non-loopback.
- */
- err = -EINVAL;
- if (ipv6_chk_addr_and_flags(net, gw_addr,
- gwa_type & IPV6_ADDR_LINKLOCAL ?
- dev : NULL, 0, 0)) {
- NL_SET_ERR_MSG(extack, "Invalid gateway address");
+ err = ip6_validate_gw(net, cfg, &dev, &idev, extack);
+ if (err)
goto out;
- }
- rt->rt6i_gateway = *gw_addr;
-
- if (gwa_type != (IPV6_ADDR_LINKLOCAL|IPV6_ADDR_UNICAST)) {
- /* IPv6 strictly inhibits using not link-local
- addresses as nexthop address.
- Otherwise, router will not able to send redirects.
- It is very good, but in some (rare!) circumstances
- (SIT, PtP, NBMA NOARP links) it is handy to allow
- some exceptions. --ANK
- We allow IPv4-mapped nexthops to support RFC4798-type
- addressing
- */
- if (!(gwa_type & (IPV6_ADDR_UNICAST |
- IPV6_ADDR_MAPPED))) {
- NL_SET_ERR_MSG(extack,
- "Invalid gateway address");
- goto out;
- }
- if (cfg->fc_flags & RTNH_F_ONLINK) {
- err = ip6_route_check_nh_onlink(net, cfg, dev,
- extack);
- } else {
- err = ip6_route_check_nh(net, cfg, &dev, &idev);
- }
- if (err)
- goto out;
- }
- err = -EINVAL;
- if (!dev) {
- NL_SET_ERR_MSG(extack, "Egress device not specified");
- goto out;
- } else if (dev->flags & IFF_LOOPBACK) {
- NL_SET_ERR_MSG(extack,
- "Egress device can not be loopback device for this route");
- goto out;
- }
+ rt->rt6i_gateway = cfg->fc_gateway;
}
err = -ENODEV;
--
2.11.0
next prev parent reply other threads:[~2018-03-07 3:58 UTC|newest]
Thread overview: 10+ messages / expand[flat|nested] mbox.gz Atom feed top
2018-03-07 3:58 [PATCH v3 net-next 0/5] net/ipv6: Address checks need to consider the L3 domain David Ahern
2018-03-07 3:58 ` David Ahern [this message]
2018-03-07 3:58 ` [PATCH v3 net-next 2/5] " David Ahern
2018-03-07 11:53 ` Kirill Tkhai
2018-03-07 11:59 ` Kirill Tkhai
2018-03-07 17:28 ` David Ahern
2018-03-07 19:53 ` David Ahern
2018-03-07 3:58 ` [PATCH v3 net-next 3/5] selftests: fib_tests: Use an alias for ip command David Ahern
2018-03-07 3:58 ` [PATCH v3 net-next 4/5] selftests: fib_tests: Allow user to run a specific test David Ahern
2018-03-07 3:58 ` [PATCH v3 net-next 5/5] selftests: fib_tests: Add IPv6 nexthop spec tests David Ahern
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20180307035841.774-2-dsahern@gmail.com \
--to=dsahern@gmail.com \
--cc=idosch@idosch.org \
--cc=netdev@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.