Re: [PATCH 0/4] RFC CPSW switchdev mode

[Andrew Lunn <andrew@lunn.ch>]

> 1) boot, ping no vlan
> 
> # ip link add name br0 type bridge
> # echo 0 > /sys/class/net/br0/bridge/default_pvid
> # ip link set dev eth2 master br0
> # ip link set dev eth0 master br0
> # ip link set dev eth1 master br0
> # ifconfig br0 192.168.1.2
> 
> *Note*: I've had to disable default_pvid as otherwise linux Bridge adds
> and offloads default vlan 1, but default configuration for CPSW driver is vid 0.
> +  CPSW specific - it can't untag packets for P0.
> Another option I've found:
> # ip link set dev br0 type bridge vlan_filtering 1.
> but anyway, I've found it confusing that Linux bridge adds default vlan when vlan_filtering == 0

There are three different configurations here you need to worry about,
with respect to vlans:

# CONFIG_VLAN_8021Q is not set

So you don't have any vlan support in the kernel.

CONFIG_VLAN_8021Q=y, vlan_filtering = 0

So you have vlans, but filtering is off

CONFIG_VLAN_8021Q=y, vlan_filtering = 1

So you have vlans, and filtering is on.

Even with vlan_filtering off, the bridge still does a little with
vlans.

And you need all three to work correctly. 

    Andrew