[U-Boot] [PATCH v2 21/21] dt-bindings: Add bindings for SPI NAND devices

[Miquel Raynal <miquel.raynal@bootlin.com>]

Hi Boris,

Boris Brezillon <boris.brezillon@bootlin.com> wrote on Thu, 12 Jul 2018
00:44:44 +0200:

> On Wed, 11 Jul 2018 17:25:29 +0200
> Miquel Raynal <miquel.raynal@bootlin.com> wrote:
> 
> > From: Boris Brezillon <boris.brezillon@bootlin.com>
> > 
> > Add bindings for SPI NAND chips.
> > 
> > Signed-off-by: Boris Brezillon <boris.brezillon@bootlin.com>
> > Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
> > ---
> >  doc/device-tree-bindings/mtd/spi-nand.txt | 27 +++++++++++++++++++++++++++
> >  1 file changed, 27 insertions(+)
> >  create mode 100644 doc/device-tree-bindings/mtd/spi-nand.txt
> > 
> > diff --git a/doc/device-tree-bindings/mtd/spi-nand.txt b/doc/device-tree-bindings/mtd/spi-nand.txt
> > new file mode 100644
> > index 0000000000..d55f80196c
> > --- /dev/null
> > +++ b/doc/device-tree-bindings/mtd/spi-nand.txt
> > @@ -0,0 +1,27 @@
> > +SPI NAND flash
> > +
> > +Required properties:
> > +- compatible: should be "spi-nand"
> > +- reg: should encode the chip-select line used to access the NAND chip
> > +
> > +Optional properties
> > +- spi-max-frequency: maximum frequency of the SPI bus the chip can operate at.
> > +		     This should encode board limitations (i.e. max freq can't
> > +		     be achieved due to crosstalk on IO lines).
> > +		     When unspecified, the driver assumes the chip can run at
> > +		     the max frequency defined in the spec (information
> > +		     extracted chip detection time).
> > +- spi-tx-bus-width: The bus width (number of data wires) that is used for MOSI.
> > +		    Only encodes the board constraints (i.e. when not all IO
> > +		    signals are routed on the board). Device constraints are
> > +		    extracted when detecting the chip, and controller
> > +		    constraints are exposed by the SPI mem controller. If this
> > +		    property is missing that means no constraint at the board
> > +		    level.
> > +- spi-rx-bus-width: The bus width (number of data wires) that is used for MISO.
> > +		    Only encodes the board constraints (i.e. when not all IO
> > +		    signals are routed on the board). Device constraints are
> > +		    extracted when detecting the chip, and controller
> > +		    constraints are exposed by the SPI mem controller. If this
> > +		    property is missing that means no constraint at the board
> > +		    level.  
> 
> This section has been dropped from the Linux doc.

Removed.

Thanks,
Miquèl