Re: how to (cross)connect two (physical) eth ports for ping test?

[Willy Tarreau <w@1wt.eu>]

On Sat, Aug 18, 2018 at 09:10:25PM +0200, Andrew Lunn wrote:
> On Sat, Aug 18, 2018 at 01:39:50PM -0400, Robert P. J. Day wrote:
> > 
> >   (i'm sure this has been explained many times before, so a link
> > covering this will almost certainly do just fine.)
> > 
> >   i want to loop one physical ethernet port into another, and just
> > ping the daylights from one to the other for stress testing. my fedora
> > laptop doesn't actually have two unused ethernet ports, so i just want
> > to emulate this by slapping a couple startech USB/net adapters into
> > two empty USB ports, setting this up, then doing it all over again
> > monday morning on the actual target system, which does have multiple
> > ethernet ports.
> > 
> >   so if someone can point me to the recipe, that would be great and
> > you can stop reading.
> > 
> >   as far as my tentative solution goes, i assume i need to put at
> > least one of the physical ports in a network namespace via "ip netns",
> > then ping from the netns to the root namespace. or, going one step
> > further, perhaps putting both interfaces into two new namespaces, and
> > setting up forwarding.
> 
> Namespaces is a good solution. Something like this should work:
> 
> ip netns add namespace1
> ip netns add namespace2
> 
> ip link set eth1 netns namespace1
> ip link set eth2 netns namespace2
> 
> ip netns exec namespace1 \
>         ip addr add 10.42.42.42/24 dev eth1
> 
> ip netns exec namespace1 \
>         ip link set eth1 up
> 
> ip netns exec namespace2 \
>         ip addr add 10.42.42.24/24 dev eth2
> 
> ip netns exec namespace2 \
>         ip link set eth2 up
> 
> ip netns exec namespace1 \
>         ping 10.42.42.24
> 
> You might also want to consider iperf3 for stress testing, depending
> on the sort of stress you need.

FWIW I have a setup somewhere involving ip rule + ip route which achieves
the same without involving namespaces. It's a bit hackish but sometimes
convenient. I can dig if someone is interested.

Regards,
Willy