Re: [PATCH v2 00/34] ARM: dts: tegra: apalis_t30: major revamp incl. v1.1 hardware support

[Thierry Reding <thierry.reding@gmail.com>]

[-- Attachment #1: Type: text/plain, Size: 4124 bytes --]

On Fri, Aug 31, 2018 at 06:37:42PM +0200, Marcel Ziswiler wrote:
> This series is a major overhaul and adds support for the V1.1 hardware
> revision of the Toradex Apalis T30 system on module.
> 
> Changes in v2:
> - Clean-up PCIe controller/port status' as well.
> - Also move serial UART "nvidia,tegra30-hsuart" compatible to module
>   level device trees.
> - Also add two missing newlines.
> - Also replace underscores in node names with dashes.
> - Explicitly disable input of BKL1_ON as well.
> - Replace underscores in node names with dashes.
> - When running some more tests I realized that the reg-addr should
>   really be 0x3f. Fix this.
> - Get rid of fake clocks simple bus as suggested by Rob.
> - Replace "[PATCH 27/28] ARM: tegra: apalis_t30: fix pcie switch vendor
>   compatible" with "[PATCH v2 26/34] dt-bindings: add broadcom (formerly
>   plx technology) vendor prefix" as suggested by Stefan.
> - New patch as suggested by Rob.
> - New patch.
> - Drop "[PATCH 01/28] ARM: tegra: apalis_t30: enable broken-hpi on emmc"
>   which should already be handled by the broken-hpi quirk as pointed out
>   by Dmitry. If I would find more eMMC parts which exhibit the issue I
>   will add them to the quirk as a separate patch.
> - Updated V1.1 device trees with all applicable previous fixes.
> 
> Marcel Ziswiler (34):
>   ARM: tegra: apalis_t30: fix mmc1 cmd pull-up
>   ARM: tegra: apalis_t30: pull-up sd card detect pins
>   ARM: tegra: apalis_t30: add local-mac-address property
>   ARM: tegra: apalis_t30: reorder pcie properties
>   ARM: tegra: apalis_t30: annotate/clean-up pcie controller/port nodes
>   ARM: tegra: apalis_t30: reorder host1x/hdmi properties
>   ARM: tegra: apalis_t30: regulator clean-up
>   ARM: tegra: apalis_t30: add missing regulators
>   ARM: tegra: apalis_t30: annotate uarts and move compatible to board
>   ARM: tegra: apalis_t30: drop unused cami2c label
>   ARM: tegra: apalis_t30: white-space/newline clean-up
>   ARM: tegra: apalis_t30: drop unused mmc1/sd1 labels
>   ARM: tegra: apalis_t30: annotate mmc1/sd1
>   ARM: tegra: apalis_t30: move dr_mode property from phy to controller
>   ARM: tegra: apalis_t30: reorder backlight properties
>   ARM: tegra: apalis_t30: drop pwmleds
>   ARM: tegra: apalis_t30: pinmux clean-up
>   ARM: tegra: apalis_t30: add missing pinmux
>   ARM: tegra: apalis_t30: use proper irq-gpio for stmpe811
>   ARM: tegra: apalis_t30: further lm95245 temperature sensor annotation
>   ARM: tegra: apalis_t30: add i2c-thermtrip
>   ARM: tegra: apalis_t30: add proper emmc vmmc and vqmmc supplies
>   ARM: tegra: apalis_t30: enable emmc ddr52 mode
>   ARM: tegra: apalis_t30: get rid of fake clocks simple bus
>   ARM: tegra: apalis_t30: line break long compatible property line
>   dt-bindings: add broadcom (formerly plx technology) vendor prefix
>   ARM: tegra: apalis_t30: drop module level model and compatible
>   ARM: tegra: apalis_t30: drop obsolete spidev nodes
>   ARM: tegra: apalis_t30: hog group for pcie switch reset gpio
>   ARM: tegra: apalis_t30: rename hdmiddc to hdmi_ddc
>   ARM: tegra: apalis_t30: rename tps65911@2d, stmpe811@41 and
>     tps62362@60
>   ARM: tegra: apalis_t30: fix mcp2515 can controller interrupt polarity
>   ARM: tegra: apalis_t30: move hda node from carrier to module
>   ARM: tegra: apalis_t30: support v1.1 hardware revision
> 
>  Documentation/devicetree/bindings/arm/tegra.txt    |    2 +
>  .../devicetree/bindings/vendor-prefixes.txt        |    1 +
>  arch/arm/boot/dts/Makefile                         |    1 +
>  arch/arm/boot/dts/tegra30-apalis-eval.dts          |  148 +--
>  arch/arm/boot/dts/tegra30-apalis-v1.1-eval.dts     |  266 +++++
>  arch/arm/boot/dts/tegra30-apalis-v1.1.dtsi         | 1189 ++++++++++++++++++++
>  arch/arm/boot/dts/tegra30-apalis.dtsi              |  705 +++++++++---
>  7 files changed, 2064 insertions(+), 248 deletions(-)
>  create mode 100644 arch/arm/boot/dts/tegra30-apalis-v1.1-eval.dts
>  create mode 100644 arch/arm/boot/dts/tegra30-apalis-v1.1.dtsi

Applied, thanks.

Thierry

[-- Attachment #2: signature.asc --]
[-- Type: application/pgp-signature, Size: 833 bytes --]