Re: [PATCH v5 3/9] spi: Add a driver for the Freescale/NXP QuadSPI controller

[Boris Brezillon <boris.brezillon@bootlin.com>]

On Wed, 14 Nov 2018 10:43:00 +0000
Yogesh Narayan Gaur <yogeshnarayan.gaur@nxp.com> wrote:

> Hi Frieder,
> 
> [..]
> > >
> > > Ok, I will have a look at what could make the chip selection fail in
> > > case of AHB read.  
> > 
> > Could you try with this change applied:
> > 
> > @@ -503,7 +503,7 @@ static void fsl_qspi_select_mem(struct fsl_qspi *q, struct
> > spi_device *spi)
> >                          map_addr = q->memmap_phy;
> >                  else
> >                          map_addr = q->memmap_phy +
> > -                                  2 * q->devtype_data->ahb_buf_size;
> > +                                  q->devtype_data->ahb_buf_size;
> > 
> >                  qspi_writel(q, map_addr, q->iobase + QUADSPI_SFA1AD +
> > (i * 4));
> >          }
> >   
> 
> I have tried above change and also have done few more changes but still AHB read for CS1 is falling.

Have plugged a scope on the CS1 line, to make sure it's properly
asserted when the memory is accessed?

> 
> I guess we need to implement dynamic memory mapping [1] for AHB Read as was being done in previous driver implementation.
> Would try this and update you.

Sorry but I don't see why it would solve the problem we have here, but
if it does, I'd like to have a clear explanation ;-).