From mboxrd@z Thu Jan 1 00:00:00 1970 From: Sasha Levin Subject: [PATCH AUTOSEL 4.19 91/97] gpio: mvebu: only fail on missing clk if pwm is actually to be used Date: Wed, 26 Dec 2018 17:35:51 -0500 Message-ID: <20181226223557.149329-91-sashal@kernel.org> References: <20181226223557.149329-1-sashal@kernel.org> Mime-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit Return-path: In-Reply-To: <20181226223557.149329-1-sashal@kernel.org> Sender: linux-kernel-owner@vger.kernel.org To: stable@vger.kernel.org, linux-kernel@vger.kernel.org Cc: =?UTF-8?q?Uwe=20Kleine-K=C3=B6nig?= , Linus Walleij , Sasha Levin , linux-pwm@vger.kernel.org, linux-gpio@vger.kernel.org List-Id: linux-gpio@vger.kernel.org From: Uwe Kleine-König [ Upstream commit c8da642d41a6811c21177c9994aa7dc35be67d46 ] The gpio IP on Armada 370 at offset 0x18180 has neither a clk nor pwm registers. So there is no need for a clk as the pwm isn't used anyhow. So only check for the clk in the presence of the pwm registers. This fixes a failure to probe the gpio driver for the above mentioned gpio device. Fixes: 757642f9a584 ("gpio: mvebu: Add limited PWM support") Signed-off-by: Uwe Kleine-König Reviewed-by: Gregory CLEMENT Signed-off-by: Linus Walleij Signed-off-by: Sasha Levin --- drivers/gpio/gpio-mvebu.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) diff --git a/drivers/gpio/gpio-mvebu.c b/drivers/gpio/gpio-mvebu.c index 6e02148c208b..adc768f908f1 100644 --- a/drivers/gpio/gpio-mvebu.c +++ b/drivers/gpio/gpio-mvebu.c @@ -773,9 +773,6 @@ static int mvebu_pwm_probe(struct platform_device *pdev, "marvell,armada-370-gpio")) return 0; - if (IS_ERR(mvchip->clk)) - return PTR_ERR(mvchip->clk); - /* * There are only two sets of PWM configuration registers for * all the GPIO lines on those SoCs which this driver reserves @@ -786,6 +783,9 @@ static int mvebu_pwm_probe(struct platform_device *pdev, if (!res) return 0; + if (IS_ERR(mvchip->clk)) + return PTR_ERR(mvchip->clk); + /* * Use set A for lines of GPIO chip with id 0, B for GPIO chip * with id 1. Don't allow further GPIO chips to be used for PWM. -- 2.19.1