Re: [PATCH] ARM: dts: am335x-baltos: Fix PHY mode for ethernet

[Tony Lindgren <tony@atomide.com>]

* Yegor Yefremov <yegorslists@googlemail.com> [190612 08:21]:
> Hi Tony,
> 
> On Wed, Jun 12, 2019 at 10:04 AM Tony Lindgren <tony@atomide.com> wrote:
> >
> > Hi,
> >
> > * yegorslists@googlemail.com <yegorslists@googlemail.com> [190611 02:31]:
> > > From: Yegor Yefremov <yegorslists@googlemail.com>
> > >
> > > The PHY must add both tx and rx delay and not only on the tx clock.
> >
> > As we're close to -rc5, I applied this against v5.2-rc1 and merged into
> > omap-for-v5.3/dt as it seems it's optional or has been broken for a while
> > with no fixes tag. After it hits the mainline kernel during the merge
> > window you can request it be applied into the stable trees as needed.
> >
> > However, if this is urgent, let me know what regression it fixes and
> > I'll merge it into my fixes branch too.
> 
> This is the same fix as 759c962d3c9bb1a60e3b4b780daa66ee6d4be13a:
> 
>     ARM: dts: am335x-evmsk: Fix PHY mode for ethernet
> 
>     The PHY must add both tx and rx delay and not only on the tx clock.
>     The board uses AR8031_AL1A PHY where the rx delay is enabled by default,
>     the tx dealy is disabled.
> 
>     The reason why rgmii-txid worked because the rx delay was not disabled by
>     the driver so essentially we ended up with rgmii-id PHY mode.
> 
> It seems to be working in 4.19. So I think kernels 5.0, 5.1 are the
> first to be affected. Without this patch eth1 is not working on Baltos
> devices.

OK thanks so it's pretty regression recent then, I'll merge it into fixes
too.

Regards,

Tony