Re: [PATCH v2 3/3] ARM: dts: imx6qdl-kontron-samx6i: add Kontron SMARC SoM Support

[Shawn Guo <shawnguo@kernel.org>]

On Mon, Jun 17, 2019 at 06:14:32PM +0200, Marco Felsch wrote:
> From: Michael Grzeschik <m.grzeschik@pengutronix.de>
> 
> The patch adds the following interfaces according the SMARC Spec 1.1
> [1] and provided schematics:
>  - SMARC SPI0/1
>    Note: Since Kontron still uses silicon revisions below 1.3 they have
>          add a spi-nor to implement Workaround #1 of erratum ERR006282.
>  - SMARC SDIO
>  - SMARC LCD
>  - SMARC HDMI
>  - SMARC Management pins
>    Note: Kontron don't route all of these pins to the i.MX6, some are
>          routed to the SoM CPLD.
>  - SMARC GPIO
>  - SMARC CSI Camera
>    Note: As specified in [1] the data lanes are shared to cover the
>          csi and the parallel case. The case depends on the baseboard so
>          muxing the data lanes is not part of this patch.
>  - SMARC I2S
>  - SMARC Watchdog
>    Note: The watchdog output pin is routed to the CPLD and the SMARC
>          header. The CPLD performs a reset after a 30s timeout so we
>          need to enable the watchdog per default.
>  - SMARC module eeprom
> 
> Due to the lack of hardware not all of these interfaces are tesetd.
> 
> [1] https://sget.org/standards/smarc
> 
> Signed-off-by: Marco Felsch <m.felsch@pengutronix.de>

Applied, thanks.