Re: [PATCH 15/16] net: phy: adin: add ethtool get_stats support

[Andrew Lunn <andrew@lunn.ch>]

On Tue, Aug 06, 2019 at 07:11:57AM +0000, Ardelean, Alexandru wrote:
> On Mon, 2019-08-05 at 17:28 +0200, Andrew Lunn wrote:
> > [External]
> > 
> > > +struct adin_hw_stat {
> > > +	const char *string;
> > > +static void adin_get_strings(struct phy_device *phydev, u8 *data)
> > > +{
> > > +	int i;
> > > +
> > > +	for (i = 0; i < ARRAY_SIZE(adin_hw_stats); i++) {
> > > +		memcpy(data + i * ETH_GSTRING_LEN,
> > > +		       adin_hw_stats[i].string, ETH_GSTRING_LEN);
> > 
> > You define string as a char *. So it will be only as long as it should
> > be. However memcpy always copies ETH_GSTRING_LEN bytes, doing off the
> > end of the string and into whatever follows.
> > 
> 
> hmm, will use strlcpy()
> i blindedly copied memcpy() from some other driver

Hopefully that driver used const char string[ETH_GSTRING_LEN]. Then a
memcpy is safe. If not, please let me know what driver you copied.

> i'm afraid i don't understand about the snapshot feature you are mentioning;
> i.e. i don't remember seeing it in other chips;

It is frequency done at the MAC layer for statistics. You tell the
hardware to snapshot all the statistics. It atomically makes a copy of
all the statistics into a set of registers. These values are then
static, and consistent between counters. You can read them out knowing
they are not going to change.

> regarding the danger that stat->reg1 rolls over, i guess that is
> possible, but it's a bit hard to guard against;

The normal solution is the read the MSB, the LSB and then the MSB
again. If the MSB value has changed between the two reads, you know a
roll over has happened, and you need to do it all again.

     Andrew