From: Lee Jones <lee.jones@linaro.org>
To: "Vaittinen, Matti" <Matti.Vaittinen@fi.rohmeurope.com>
Cc: "mazziesaccount@gmail.com" <mazziesaccount@gmail.com>,
"dmurphy@ti.com" <dmurphy@ti.com>,
"linux-leds@vger.kernel.org" <linux-leds@vger.kernel.org>,
"linux-rtc@vger.kernel.org" <linux-rtc@vger.kernel.org>,
"linux-gpio@vger.kernel.org" <linux-gpio@vger.kernel.org>,
"linux-kernel@vger.kernel.org" <linux-kernel@vger.kernel.org>,
"alexandre.belloni@bootlin.com" <alexandre.belloni@bootlin.com>,
"mturquette@baylibre.com" <mturquette@baylibre.com>,
"lgirdwood@gmail.com" <lgirdwood@gmail.com>,
"devicetree@vger.kernel.org" <devicetree@vger.kernel.org>,
"jacek.anaszewski@gmail.com" <jacek.anaszewski@gmail.com>,
"a.zummo@towertech.it" <a.zummo@towertech.it>,
"linus.walleij@linaro.org" <linus.walleij@linaro.org>,
"mark.rutland@arm.com" <mark.rutland@arm.com>,
"robh+dt@kernel.org" <robh+dt@kernel.org>,
"bgolaszewski@baylibre.com" <bgolaszewski@baylibre.com>,
"linux-clk@vger.kernel.org" <linux-clk@vger.kernel.org>,
"sboyd@kernel.org" <sboyd@kernel.org>,
"pavel@ucw.cz" <pavel@ucw.cz>,
"broonie@kernel.org" <broonie@kernel.org>
Subject: Re: [RFC PATCH v2 02/13] dt-bindings: mfd: Document ROHM BD71828 bindings
Date: Tue, 29 Oct 2019 12:08:20 +0000 [thread overview]
Message-ID: <20191029120820.GA4484@dell> (raw)
In-Reply-To: <5c793f1308ccc6e787260b64fe6a875a8d0eb9d0.camel@fi.rohmeurope.com>
On Fri, 25 Oct 2019, Vaittinen, Matti wrote:
> Hello Dan,
>
> Thanks again for checking this :)
>
> On Thu, 2019-10-24 at 14:35 -0500, Dan Murphy wrote:
> > Matti
> >
> > On 10/24/19 6:41 AM, Matti Vaittinen wrote:
> > > ROHM BD71828 Power management IC integrates 7 buck converters, 7
> > > LDOs,
> > > a real-time clock (RTC), 3 GPO/regulator control pins, HALL input
> > > and a 32.768 kHz clock gate.
> > >
> > > Document the dt bindings drivers are using.
> > >
> > > Signed-off-by: Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com>
> > > ---
> > >
> > > No changes since v1
> > >
> > > .../bindings/mfd/rohm,bd71828-pmic.txt | 180
> > > ++++++++++++++++++
> > > 1 file changed, 180 insertions(+)
> > > create mode 100644
> > > Documentation/devicetree/bindings/mfd/rohm,bd71828-pmic.txt
> >
> > I will let maintainers weigh in here but if this is new this should
> > probably be in the yaml format to avoid conversion in the future
Yes please.
> Oh... This is new to me. I guess there are reasons for this - but I
> must say I am not excited as I have never used yaml for anything. I'll
> do as you suggest and wait for what others have to say :) Thanks for
> pointing this out though.
--
Lee Jones [李琼斯]
Linaro Services Technical Lead
Linaro.org │ Open source software for ARM SoCs
Follow Linaro: Facebook | Twitter | Blog
next prev parent reply other threads:[~2019-10-29 12:08 UTC|newest]
Thread overview: 29+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-10-24 11:40 [RFC PATCH v2 00/13] Support ROHM BD71828 PMIC Matti Vaittinen
2019-10-24 11:41 ` [RFC PATCH v2 01/13] mfd: bd71828: Support ROHM BD71828 PMIC - core Matti Vaittinen
2019-10-24 11:41 ` [RFC PATCH v2 02/13] dt-bindings: mfd: Document ROHM BD71828 bindings Matti Vaittinen
2019-10-24 19:35 ` Dan Murphy
2019-10-25 5:49 ` Vaittinen, Matti
2019-10-29 12:08 ` Lee Jones [this message]
2019-10-29 19:34 ` Rob Herring
2019-10-30 8:26 ` Vaittinen, Matti
2019-10-30 19:22 ` Rob Herring
2019-10-31 12:54 ` Vaittinen, Matti
2019-10-31 17:50 ` Rob Herring
2019-11-01 12:52 ` Vaittinen, Matti
2019-11-04 19:28 ` Rob Herring
2019-10-24 11:42 ` [RFC PATCH v2 03/13] dt-bindings: regulator: Document ROHM BD71282 regulator bindings Matti Vaittinen
2019-10-24 11:44 ` [RFC PATCH v2 04/13] mfd: input: bd71828: Add power-key support Matti Vaittinen
2019-10-24 11:44 ` [RFC PATCH v2 05/13] clk: bd718x7: Support ROHM BD71828 clk block Matti Vaittinen
2019-10-28 23:32 ` Stephen Boyd
2019-10-29 6:28 ` Vaittinen, Matti
[not found] ` <20191105005541.7913220717@mail.kernel.org>
2019-11-05 8:11 ` Vaittinen, Matti
2019-10-24 11:45 ` [RFC PATCH v2 06/13] regulator: bd718x7: Split driver to common and bd718x7 specific parts Matti Vaittinen
2019-10-24 11:46 ` [RFC PATCH v2 07/13] regulator: bd71828: Basic support for ROHM bd71828 PMIC regulators Matti Vaittinen
2019-10-24 11:46 ` [RFC PATCH v2 08/13] regulator: bd71828: Add GPIO based run-level control for regulators Matti Vaittinen
2019-10-24 11:47 ` [RFC PATCH v2 09/13] regulator: bd71828: enhanced run-level support Matti Vaittinen
2019-10-24 11:47 ` [RFC PATCH v2 10/13] regulator: bd71828: Support in-kernel APIs to change run-level Matti Vaittinen
2019-10-24 11:50 ` [RFC PATCH v2 11/13] rtc: bd70528 add BD71828 support Matti Vaittinen
2019-10-24 11:50 ` [RFC PATCH v2 12/13] gpio: bd71828: Initial support for ROHM BD71828 PMIC GPIOs Matti Vaittinen
2019-10-24 11:59 ` Linus Walleij
2019-10-24 13:34 ` Vaittinen, Matti
2019-10-24 11:52 ` [RFC PATCH v2 13/13] led: bd71828: Support LED outputs on ROHM BD71828 PMIC Matti Vaittinen
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20191029120820.GA4484@dell \
--to=lee.jones@linaro.org \
--cc=Matti.Vaittinen@fi.rohmeurope.com \
--cc=a.zummo@towertech.it \
--cc=alexandre.belloni@bootlin.com \
--cc=bgolaszewski@baylibre.com \
--cc=broonie@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=dmurphy@ti.com \
--cc=jacek.anaszewski@gmail.com \
--cc=lgirdwood@gmail.com \
--cc=linus.walleij@linaro.org \
--cc=linux-clk@vger.kernel.org \
--cc=linux-gpio@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-leds@vger.kernel.org \
--cc=linux-rtc@vger.kernel.org \
--cc=mark.rutland@arm.com \
--cc=mazziesaccount@gmail.com \
--cc=mturquette@baylibre.com \
--cc=pavel@ucw.cz \
--cc=robh+dt@kernel.org \
--cc=sboyd@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.