Re: [PATCH net-next 10/12] net: dsa: vitesse: move vsc73xx driver to a separate folder

[Alexandre Belloni <alexandre.belloni@bootlin.com>]

On 13/11/2019 08:38:22+0100, Allan W. Nielsen wrote:
> > > > The way I see an Ocelot DSA driver, it would be done a la mv88e6xxx,
> > > > aka a single struct dsa_switch_ops registered for the entire family,
> > > > and function pointers where the implementation differs. You're not
> > > > proposing that here, but rather that each switch driver works in
> > > > parallel with each other, and they all call into the Ocelot core. That
> > > > would produce a lot more boilerplate, I think.
> > > > And if the DSA driver for Ocelot ends up supporting more than 1
> > > > device, its name should better not contain "vsc9959" since that's
> > > > rather specific.
> > > A vsc7511/12 will not share code with felix/vsc9959. I do not expect any other
> > > IP/chip will be register compatible with vsc9959.
> > I don't exactly understand this comment. Register-incompatible in a
> > logical sense, or in a layout sense? Judging from the attachment in
> > chapter 6 of the VSC7511 datasheet [1], at least the basic
> > functionality appears to be almost the same. And for the rest, there's
> > regmap magic.
> My point is that vsc7511 has more in commen with vsc7514 than it has with
> felix/vsc9959.
> 
> vsc7511 will use the same regmaps as those in vsc7514 (with different helper
> functions as it will be accessing the reguster via SPI).
> 

regmap will properly abstract the underlying bus, this was the whole
point of using it.


-- 
Alexandre Belloni, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com