Re: [PATCH v2 0/5] ti-sysc support for PRUSS

[Tony Lindgren <tony@atomide.com>]

* Suman Anna <s-anna@ti.com> [200227 14:29]:
> Hi Tony,
> 
> The following is a revised series of the ti-sysc support for PRUSS.
> Please refer to the original series cover-letter [1] for details.
> 
> Following are the main changes in v2:
>  - Drop the enabling of the interconnect nodes from various AM335x and
>    AM437x board dts files (last 7 patches from original series)
>  - Enable the target-module node for AM437x by default. None of the
>    current AM437x board dts files use AM4372, so there should not be
>    any regressions.
> 
> We can drop the status=disabled in the am33xx.dtsi file once we add the
> SoC revision support for AM335x SoCs. This is already disabled before the
> series as well. I have identified a few boards which use the older SoCs
> that can disable the node in dts, but there were few others which can
> use any of the SoCs, so those will definitely require the SoC device
> match logic and an additional PRUSS disable quirk in the ti-sysc bus
> driver.

OK thanks, applied and pushed out into omap-for-v5.7/ti-sysc-drop-pdata.

Regards,

Tony