[PATCH] kselftest/runner: allow to properly deliver signals to tests

[Andrea Righi <andrea.righi@canonical.com>]

While running seccomp_bpf, kill_after_ptrace() gets stuck if we run it
via /usr/bin/timeout (that is the default), until the timeout expires.

This is because /usr/bin/timeout is preventing to properly deliver
signals to ptrace'd children (SIGSYS in this case).

This problem can be easily reproduced by running:

 $ sudo make TARGETS=seccomp kselftest
 ...

 # [ RUN      ] TRACE_syscall.skip_a#
 not ok 1 selftests: seccomp: seccomp_bpf # TIMEOUT

The test is hanging at this point until the timeout expires and then it
reports the timeout error.

Prevent this problem by passing --foreground to /usr/bin/timeout,
allowing to properly deliver signals to children processes.

Signed-off-by: Andrea Righi <andrea.righi@canonical.com>
---
 tools/testing/selftests/kselftest/runner.sh | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/tools/testing/selftests/kselftest/runner.sh b/tools/testing/selftests/kselftest/runner.sh
index e84d901f8567..676b3a8b114d 100644
--- a/tools/testing/selftests/kselftest/runner.sh
+++ b/tools/testing/selftests/kselftest/runner.sh
@@ -33,7 +33,7 @@ tap_timeout()
 {
 	# Make sure tests will time out if utility is available.
 	if [ -x /usr/bin/timeout ] ; then
-		/usr/bin/timeout "$kselftest_timeout" "$1"
+		/usr/bin/timeout --foreground "$kselftest_timeout" "$1"
 	else
 		"$1"
 	fi
-- 
2.25.1