Re: [PATCH 2/4] usb: typec: mux: intel_pmc_mux: Support for static SBU/HSL orientation

[Heikki Krogerus <heikki.krogerus@linux.intel.com>]

On Fri, May 08, 2020 at 02:18:44PM +0300, Heikki Krogerus wrote:
> Hi Prashant,
> 
> On Thu, May 07, 2020 at 03:40:41PM -0700, Prashant Malani wrote:
> > > +static int sbu_orientation(struct pmc_usb_port *port)
> > > +{
> > > +	if (port->sbu_orientation)
> > > +		return port->sbu_orientation - 1;
> > > +
> > > +	return port->orientation - 1;
> > > +}
> > > +
> > > +static int hsl_orientation(struct pmc_usb_port *port)
> > > +{
> > > +	if (port->hsl_orientation)
> > > +		return port->hsl_orientation - 1;
> > > +
> > > +	return port->orientation - 1;
> > > +}
> > > +
> > >  static int pmc_usb_command(struct pmc_usb_port *port, u8 *msg, u32 len)
> > >  {
> > >  	u8 response[4];
> > > @@ -151,8 +170,9 @@ pmc_usb_mux_dp(struct pmc_usb_port *port, struct typec_mux_state *state)
> > >  
> > >  	req.mode_data = (port->orientation - 1) << PMC_USB_ALTMODE_ORI_SHIFT;
> > >  	req.mode_data |= (port->role - 1) << PMC_USB_ALTMODE_UFP_SHIFT;
> > > -	req.mode_data |= (port->orientation - 1) << PMC_USB_ALTMODE_ORI_AUX_SHIFT;
> > > -	req.mode_data |= (port->orientation - 1) << PMC_USB_ALTMODE_ORI_HSL_SHIFT;
> > > +
> > > +	req.mode_data |= sbu_orientation(port) << PMC_USB_ALTMODE_ORI_AUX_SHIFT;
> > 
> > I'm curious to know what would happen when sbu-orientation == "normal".
> > That means |port->sbu_orientation| == 1.
> > 
> > It sounds like what should happen is the AUX_SHIFT orientation
> > setting should follow what |port->orientation| is, but here it
> > looks like it will always be set to |port->sbu_orientation - 1|, i.e 0,
> > even if port->orientation == TYPEC_ORIENTATION_REVERSE, i.e 2, meaning
> > it should be set to 1 ?
> 
> I'll double check this, and get back to you..

This is not exactly an answer to your question, but it seems that
those bits are only valid if "Alternate-Direct" message is used.
Currently the driver does not support that message.

I think the correct thing to do now is to remove the two lines from
the driver where those bits (ORI-HSL and ORI-Aux) are set.

Let me know if that's OK, and I'll update the series.

thanks,

-- 
heikki