From: Boris Brezillon <boris.brezillon@collabora.com>
To: Miquel Raynal <miquel.raynal@bootlin.com>
Cc: Michal Simek <monstr@monstr.eu>,
Vignesh Raghavendra <vigneshr@ti.com>,
Tudor Ambarus <Tudor.Ambarus@microchip.com>,
Richard Weinberger <richard@nod.at>,
linux-mtd@lists.infradead.org,
Thomas Petazzoni <thomas.petazzoni@bootlin.com>,
Naga Sureshkumar Relli <nagasure@xilinx.com>
Subject: Re: [PATCH v5 3/8] mtd: rawnand: Ensure the number of bitflips is consistent
Date: Tue, 19 May 2020 10:42:05 +0200 [thread overview]
Message-ID: <20200519104205.7c130931@collabora.com> (raw)
In-Reply-To: <20200519074549.23673-4-miquel.raynal@bootlin.com>
On Tue, 19 May 2020 09:45:44 +0200
Miquel Raynal <miquel.raynal@bootlin.com> wrote:
> The main NAND read page function can loop over "page reads" many times
> in if the reading reports uncorrectable error(s) and if the chip
> supports the read_retry feature.
>
> In this case, the number of bitflips is summarized between
> attempts. Fix this by re-initializing the entire mtd_ecc_stats object
> each time we retry.
>
> Suggested-by: Boris Brezillon <boris.brezillon@collabora.com>
> Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Reviewed-by: Boris Brezillon <boris.brezillon@collabora.com>
> ---
> drivers/mtd/nand/raw/nand_base.c | 10 +++++-----
> 1 file changed, 5 insertions(+), 5 deletions(-)
>
> diff --git a/drivers/mtd/nand/raw/nand_base.c b/drivers/mtd/nand/raw/nand_base.c
> index 2bef01e21533..65e9b2fa2fc5 100644
> --- a/drivers/mtd/nand/raw/nand_base.c
> +++ b/drivers/mtd/nand/raw/nand_base.c
> @@ -3288,7 +3288,7 @@ static int nand_do_read_ops(struct nand_chip *chip, loff_t from,
> oob_required = oob ? 1 : 0;
>
> while (1) {
> - unsigned int ecc_failures = mtd->ecc_stats.failed;
> + struct mtd_ecc_stats ecc_stats = mtd->ecc_stats;
>
> bytes = min(mtd->writesize - col, readlen);
> aligned = (bytes == mtd->writesize);
> @@ -3339,7 +3339,7 @@ static int nand_do_read_ops(struct nand_chip *chip, loff_t from,
> */
> if (use_bounce_buf) {
> if (!NAND_HAS_SUBPAGE_READ(chip) && !oob &&
> - !(mtd->ecc_stats.failed - ecc_failures) &&
> + !(mtd->ecc_stats.failed - ecc_stats.failed) &&
> (ops->mode != MTD_OPS_RAW)) {
> chip->pagecache.page = realpage;
> chip->pagecache.bitflips = ret;
> @@ -3362,7 +3362,7 @@ static int nand_do_read_ops(struct nand_chip *chip, loff_t from,
>
> nand_wait_readrdy(chip);
>
> - if (mtd->ecc_stats.failed - ecc_failures) {
> + if (mtd->ecc_stats.failed - ecc_stats.failed) {
> if (retry_mode + 1 < chip->read_retries) {
> retry_mode++;
> ret = nand_setup_read_retry(chip,
> @@ -3370,8 +3370,8 @@ static int nand_do_read_ops(struct nand_chip *chip, loff_t from,
> if (ret < 0)
> break;
>
> - /* Reset failures; retry */
> - mtd->ecc_stats.failed = ecc_failures;
> + /* Reset ecc_stats; retry */
> + mtd->ecc_stats = ecc_stats;
> goto read_retry;
> } else {
> /* No more retry modes; real failure */
______________________________________________________
Linux MTD discussion mailing list
http://lists.infradead.org/mailman/listinfo/linux-mtd/
next prev parent reply other threads:[~2020-05-19 8:42 UTC|newest]
Thread overview: 23+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-05-19 7:45 [PATCH v5 0/8] New Arasan NAND controller driver Miquel Raynal
2020-05-19 7:45 ` [PATCH v5 1/8] lib/bch: Rework a little bit the exported function names Miquel Raynal
2020-05-24 19:10 ` Miquel Raynal
2020-05-19 7:45 ` [PATCH v5 2/8] lib/bch: Allow easy bit swapping Miquel Raynal
2020-05-19 8:41 ` Boris Brezillon
2020-05-24 19:09 ` Miquel Raynal
2020-05-19 7:45 ` [PATCH v5 3/8] mtd: rawnand: Ensure the number of bitflips is consistent Miquel Raynal
2020-05-19 8:42 ` Boris Brezillon [this message]
2020-05-24 19:09 ` Miquel Raynal
2020-05-19 7:45 ` [PATCH v5 4/8] mtd: rawnand: Add nand_extract_bits() Miquel Raynal
2020-05-19 8:48 ` Boris Brezillon
2020-05-19 12:15 ` Miquel Raynal
2020-05-24 19:09 ` Miquel Raynal
2020-05-19 7:45 ` [PATCH v5 5/8] MAINTAINERS: Add Arasan NAND controller and bindings Miquel Raynal
2020-05-24 19:09 ` Miquel Raynal
2020-05-19 7:45 ` [PATCH v5 6/8] dt-bindings: mtd: Document ARASAN NAND bindings Miquel Raynal
2020-05-24 19:09 ` Miquel Raynal
2020-05-19 7:45 ` [PATCH v5 7/8] mtd: rawnand: arasan: Add new Arasan NAND controller Miquel Raynal
2020-05-19 8:50 ` Boris Brezillon
2020-05-24 19:09 ` Miquel Raynal
2020-05-19 7:45 ` [PATCH v5 8/8] mtd: rawnand: arasan: Support the hardware BCH ECC engine Miquel Raynal
2020-05-19 8:51 ` Boris Brezillon
2020-05-24 19:09 ` Miquel Raynal
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20200519104205.7c130931@collabora.com \
--to=boris.brezillon@collabora.com \
--cc=Tudor.Ambarus@microchip.com \
--cc=linux-mtd@lists.infradead.org \
--cc=miquel.raynal@bootlin.com \
--cc=monstr@monstr.eu \
--cc=nagasure@xilinx.com \
--cc=richard@nod.at \
--cc=thomas.petazzoni@bootlin.com \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.