Re: [PATCH v3 0/5] Add a vhost RPMsg API

[Guennadi Liakhovetski <guennadi.liakhovetski@linux.intel.com>]

Hi Jason,

On Fri, May 29, 2020 at 02:01:53PM +0800, Jason Wang wrote:
> 
> On 2020/5/28 上午2:05, Guennadi Liakhovetski wrote:
> > v3:
> > - address several checkpatch warnings
> > - address comments from Mathieu Poirier
> > 
> > v2:
> > - update patch #5 with a correct vhost_dev_init() prototype
> > - drop patch #6 - it depends on a different patch, that is currently
> >    an RFC
> > - address comments from Pierre-Louis Bossart:
> >    * remove "default n" from Kconfig
> > 
> > Linux supports RPMsg over VirtIO for "remote processor" /AMP use
> > cases. It can however also be used for virtualisation scenarios,
> > e.g. when using KVM to run Linux on both the host and the guests.
> > This patch set adds a wrapper API to facilitate writing vhost
> > drivers for such RPMsg-based solutions. The first use case is an
> > audio DSP virtualisation project, currently under development, ready
> > for review and submission, available at
> > https://github.com/thesofproject/linux/pull/1501/commits
> > A further patch for the ADSP vhost RPMsg driver will be sent
> > separately for review only since it cannot be merged without audio
> > patches being upstreamed first.
> 
> 
> Hi:
> 
> It would be hard to evaluate this series without a real user. So if
> possible, I suggest to post the actual user for vhost rpmsg API.

Sure, the whole series is available at 
https://github.com/thesofproject/linux/pull/1501/commits or would you 
prefer the missing patches posted to the lists too?

Thanks
Guennadi