Re: [ANNOUNCE] unionmount-testsuite: master branch updated to 9c60a9c

[Vivek Goyal <vgoyal@redhat.com>]

On Fri, Jun 19, 2020 at 06:29:08AM +0300, Amir Goldstein wrote:

[..]
> > Hi Amir,
> >
> > I am running these tests with.
> >
> > UNIONMOUNT_BASEDIR="/mnt/foo/"
> 
> I suspect there is a bug with trailing / in UNIONMOUNT_BASEDIR
> I did not test with trailing /
> Can you try without it?

Hi Amir,

This indeed is trailing / issue. I removed it and things are working fine.

> 
> >
> > - ./run --ov runs fine. But when I try to run it again it complains
> >   that.
> >
> >   rm: cannot remove '/mnt/overlayfs//m': Device or resource busy
> >
> > So I have to first unmount /mnt/overlayfs/m/ and then run tests
> > again.
> >
> > I think it will be nice if it can clear the environment by itself.
> >
> 
> It should.
> All the tests I tried cleaned up previous test env automatically.
> The only case where explicit cleanup is needed is before changing
> context and modifying envvars.

After removing trailing /, cleanup was fine too.

> 
> > - I am running one the recent kernel (5.7.0+) and following errors
> >   out.
> >
> > # ./run --ov --verify
> > Environment variables:
> > UNIONMOUNT_BASEDIR=/mnt/overlayfs/
> >
> > ***
> > *** ./run --ov --samefs --ts=0 open-plain
> > ***
> > TEST open-plain.py:10: Open O_RDONLY
> > /mnt/overlayfs/m/a/foo100: not on union mount
> >
> > Will spend more time to figure out what happened.
> >
> > - I am planning to use these environment variables and run overlay over
> >   virtiofs tests. Can I do the same thing with xfstests overlay tests.
> >   In README.overlay I see that I need to specify two separate devices.
> >   Can I specify to directories (and not devices) to be used as TEST
> >   and SCRATCH and run overlay test.
> 
> As far as I can tell, SCRATCH_DEV and TEST_DEV are directories
> in all those non-block filesystems including virtiofs:
> _scratch_mkfs()
> ...
>       case $FSTYP in
>         nfs*|cifs|ceph|overlay|glusterfs|pvfs2|9p|virtiofs)
>                 # unable to re-create this fstyp, just remove all files in
>                 # $SCRATCH_MNT to avoid EEXIST caused by the leftover files
>                 # created in previous runs
>                 _scratch_cleanup_files
> 
> So I think you just need to set SCRATCH_DEV and TEST_DEV to
> two different directories and you are good to go for running
> check or check -overlay.

It seems to work. I am seeing bunch of failures but that probably 
are issues with virtiofs and overlayfs interaction. Will look into
these one by one.

Thanks
Vivek